Configuring the Connection
1. Open Internet Explorer. In the upper right hand side, select 'Internet Options".
2.
Click on the "Security" tab.
3.
Make sure "Enabled Protected Mode" is checked.
4.
Click on the "Trusted Sites"
5.
Click on the button that says "Sites"
4. In the field that says "Add website to the
zone", type https://asa-vpn.unf.edu".
5. Then click the "Add” button.
6. Click the "Close" button and then the "OK"
button.
6. In Internet Explorer, Go to https://asa-vpn.unf.edu
7. Wait a few minutes until you see a log in screen.
8. When the log in screen appears - choose
"employee" as the Group.
9. Log in using your UNF ID and password.
10. This window will appear. Wait to see if the
software begins to install. You will know it has
because you will see some security windows
popup (see below). If the install stalls, then
click the “Download” button (and then install).
10. It will take a few minutes to install. Click "yes" or "Allow" to any security popups. Click “Install.
11. You should see a Downloader window appear and the software will begin to install.
12. Click “yes”.
13. Wait while the VPN connection is established.
14. After install is complete, you will see this
window. Click “OK”.
You should be connected to VPN.
Disconnecting and Connecting to from AnyConnect VPN
Go to your Task Tray, and select the AnyConnect icon.
Click the “Disconnect” button to end your connection.
Click the “Connect” button to begin a connection.