Thanks for shopping with Improvements®!
Animated Tinsel Dinosaur
Item #433892
A. Hat
C. Spikes
Qty: 1
Qty: 5 pairs
B. Neck/Head
Qty: 1
D. Body
Qty: 2 halves
Qty: 1
E. Leg
Qty: 4
F. Tail
G. Scarf
Qty: 1
H. Cotter pin
I. Ground Stake
Qty: 4
Qty: 2
J. Plastic Ties
Note:





Plastic caps are used to protect the end of the metal posts. Remove the caps before assembling.
No tools are required for assembly.
Wait to dispose of the packing material until assembly is complete and all parts are accounted for.
Two people might be helpful for assembly.
Lay out all parts in the order of their part letter.
If you have questions regarding this product, call
1-800-642-2112 Mon.-Fri. 9:00-5:00 EST (Ohio)
To order, call
1-800-642-2112
West Chester, OH 45069
Made in China
1013
and ask for our product specialists, or e-mail:
[email protected]
See many more products on the Internet!
www.ImprovementsCatalog.com
Step 1: Align two Halves of Body (D) with each other Step 2: Insert two metal rods of each Leg (E) into the
and fasten them together with the Plastic Ties (J).
matching sleeves in the body. Insert the rod of each
Spike (C) into the corresponding sleeve on the top of
the body respectively;
Step 3: Attach the Head (B) to the Body by matching Step 4: Insert the rod of the Hat (A) into the sleeve on
the two metal hooks on rear edge of the Head to the
the head. Wrap the Scarf (G) around the neck of
matching sleeve in the front edge of the Body. Attach Dinosaur.
the Tail (F) to the Body by matching the two metal
Secure the product to the ground with the Ground
hooks on rear edge of the Tail to the back edge of
Stakes (I).
the Body. Insert the end of the long metal connecting
bar attached to the motor into the tube welding on
the wire edge of Neck & Head (B) and lock with the
Cotter Pin (H). Insert the end of the plastic
connecting bar attached to the motor into the tube
welding on the wire edge of the Tail (F) and lock with
the Cotter Pin (H)
Use any extra Plastic Ties (J) as needed to add to the security of any parts or wires.