Material Safety Data Sheet
U.S. Department of Labor
May be used to comply with
OSHA's Hazard Communication Standard,
29 CFR 1910.1200. Standard must be
consulted for specific requirements.
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved
OMB No. 1218-0072
IDENTITY (As Used on Label and List)
OPC Drum in DK-15 for Facsimile DP120F and DP125F
Section I
Manufacture's Name
Emergency Telephone Number
TOSHIBA TEC CORPORATION
Address (Number, Street, City, State, and ZIP Code) Telephone Number for Information
Shuwa-Shiba Park Bldg. B, 7th floor
03-3438-6945
2-4-1, Shibakoen
Date Prepared
Minato-ku, Tokyo 105, JAPAN
6-Mar-00
Signature of Preparer (optional )
Section II - Hazardous Ingredients/Identity Information
Hazardous Components
Other Limits
OSHA PEL ACGIH TLV Recommended % (optional)
(Specific Chemical Identity; Common Name(s))
Binder resin
Not listed
Not listed
None
<1.0wt%
Photoconductive material
Not listed
Not listed
None
<1.0wt%
Additive
Not listed
Not listed
None
<0.1wt%
Aluminum
15mg/m3
10mg/m3(TWA)*None
<98.2wt%
*Listed not as aluminum tube but aluminum dust.
Section III - Physical/Chemical Characteristics
Specific Gravity (H2O = 1)
Boiling Point
No data
Vapor Pressure (mm Hg.)
2.7(Al)
Melting Point
N. A.
Vapor Density (AIR=1)
660℃(Al)
Evaporation Rate
N. A.
(Butyl Acetate = 1)
N. A.
Solubility in Water
Negligible
Appearance and Odor
Green cylinder, no odor
Section IV - Fire and Explosion Hazard Data
Flash Point (Method used)
Flammable Limits
N. A.
LEL
UEL
N.A.
N.A.
Extinguishing Media
CO2 and dry chemicals
Special Fire Fighting Procedures
Self contained breathing apparatus and full protection against dust and fumes.
(In case that a large quantity of drums produces fumes or vapors at a high temperature.)
Material Safety Data Sheet
U.S. Department of Labor
May be used to comply with
OSHA's Hazard Communication Standard,
29 CFR 1910.1200. Standard must be
consulted for specific requirements.
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved
OMB No. 1218-0072
IDENTITY (As Used on Label and List)
Carrier (DFC350) in TK-15 for Facsimile DP120F and DP125F
Section I
Manufacture's Name
Emergency Telephone Number
TOSHIBA TEC CORPORATION
Address (Number, Street, City, State, and ZIP Code) Telephone Number for Information
Shuwa-Shiba Park Bldg. B, 7th floor
03-3438-6945
2-4-1, Shibakoen
Date Prepared
Minato-ku, Tokyo 105, JAPAN
6-Mar-00
Signature of Preparer (optional )
Section II - Hazardous Ingredients/Identity Information
Hazardous Components
Other Limits
OSHA PEL ACGIH TLVRecommended % (optional)
(Specific Chemical Identity; Common Name(s))
Non hazardous ingredients
DFC350 is comprised of a composition reprisented by following formula.
(CuO) (ZnO) (Fe2O3)
CAS No.
TSCA
CuO :
1317-38-0
017971
ZnO :
1314-13-2
017929
Fe2O3:
1309-37-1
017884
Section III - Physical/Chemical Characteristics
Specific Gravity (H2O = 1)
Boiling Point
N. A.
Vapor Pressure (mm Hg.)
5.2
Melting Point
N. A.
Vapor Density (AIR=1)
1400℃
Evaporation Rate
N. A.
(Butyl Acetate = 1)
Trace
Solubility in Water
Trace
Appearance and Odor
dark gray powder and Odorless
Section IV - Fire and Explosion Hazard Data
Flash Point (Method used)
Flammable Limits
N. A.
LEL
UEL
N.A.
N.A.
Extinguishing Media
Incombustible substance
Special Fire Fighting Procedures
Incombustible substance
Unusual Fire and Explosion Hazards
Non-known
(Reproduce locally)
OSHA 174, Sept. 1985
*N. A.
Not Applicable
Section V - Reactivity Data
Stability
Unstable
Conditions to Avoid
Stable
X
Acid
Incompatibility (Materials to Avoid)
Acids
Hazardous Decomposition or Byproducts
Nothing
Hazardous
May Occur
Conditions to Avoid
Polymerization
Will Not Occur
Nothing
X
Section VI-Health Hazard Data
Route(s) of Entry:
Inhalation?
Yes
Skin?
No
Ingestion?
Possible but very unusual
Health Hazards (Acute and Chronic)
Non-known
Carcinogenicity:
NTP?
IARC Monographs?
No
No
OSHA Regulated?
No
Signs and Symptoms of Exposure
Non-known
Medical Conditions
Generally Aggravated by Exposure
Non-known
Emergency and First Aid Procedures
EYE CONTACT: flush with water until remove foreign body.
INGESTION: in case of a large quantity, let a person see a doctor.
Section VII-Precautions for Safe Handing and Use
Steps to Be Taken in Case Material is Released or Spilled
Clean by sweeping
Waste Disposal Method
Dispose of the materials in accordance with local regulations as incombustible substance.
Precautions to Be Taken in Handing and Storing
Put on mask and goggles. Store in dry place.
Other Precautions
Non-known
Section VIII - Control Measures
Respiratory Protection (Specify Type)
Preferable to put on single mask.
Ventilation
Local Exhaust
Special
Recommended
Non-known
Mechanical (General)
Other
Recommended
Non-known
Protective Gloves
Eye Protection
Preferable to clothe gloves.
Preferable to put on goggles.
Other Protective Clothing or Equipment
Eyewash equipment etc, as required by your company.
Work/Hygienic Practices
Wash after handling.
**; This material is made from same components as TUFTONE HFT-3 but the ratio of components is different.
Material Safety Data Sheet
U.S. Department of Labor
May be used to comply with
OSHA's Hazard Communication Standard,
29 CFR 1910.1200. Standard must be
consulted for specific requirements.
Occupational Safety and Health Administration
(Non-Mandatory Form)
Form Approved
OMB No. 1218-0072
IDENTITY (As Used on Label and List)
Magnetic Toner in TK-15 for Facsimile DP120F and DP125F
Section I
Manufacture's Name
Emergency Telephone Number
TOSHIBA TEC CORPORATION
Address (Number, Street, City, State, and ZIP Code) Telephone Number for Information
Shuwa-Shiba Park Bldg. B, 7th floor
03-3438-6945
2-4-1, Shibakoen
Date Prepared
Minato-ku, Tokyo 105, JAPAN
6-Mar-00
Signature of Preparer (optional )
Section II - Hazardous Ingredients/Identity Information
Hazardous Components
Other Limits
OSHA PEL ACGIH TLVRecommended % (optional)
(Specific Chemical Identity; Common Name(s))
No hazardous material plesent.
Chemical Name (common & IUPAC)
CAS No.
%
Stylene acrylate copolymer
25036-16-2
40-60
Magnetite
1317-61-9
40-55
Polypropylene wax
9003-07-0
1- 5
67762-90-7
0.1- 1
Silicon dioxide amorphous
Section III - Physical/Chemical Characteristics
Specific Gravity (H2O = 1)
Boiling Point
N. A.
Vapor Pressure (mm Hg.)
1.5-2.0
Melting Point
110℃
℃
N. A.
Vapor Density (AIR=1)
Evaporation Rate
N. A.
(Butyl Acetate = 1)
N. A.
Solubility in Water
Insoluble
Appearance and Odor
Black powder ,faint odor
Section IV - Fire and Explosion Hazard Data
Flash Point (Method used)
N. A.
Flammable Limits
LEL
UEL
N.A.
N.A.
N.A.
Extinguishing Media
Water fog, foam, CO2, dry chemical
Special Fire Fighting Procedures
Avoid inhalation of smoke. Wear MSHA/NIOSH self contained breathing
apparatus. Cool fire exposed containers with water spray.
Unusual Fire and Explosion Hazards
This materials has no unusual fire or explosion hazards.
(Reproduce locally)
OSHA 174, Sept. 1985
*N. A.
Not Applicable
Section V - Reactivity Data
Stability
Unstable
Conditions to Avoid
Stable
Avoid open flame
X
Incompatibility (Materials to Avoid)
None with common materials with which the product may reasonably come into contact.
Hazardous Decomposition or Byproducts
Toxic decomposition products formed on combution.
Hazardous
May Occur
Conditions to Avoid
Polymerization
N.A.
Will Not Occur
X
Section VI-Health Hazard Data
Route(s) of Entry:
Inhalation?
Skin?
Ingestion?
Health Hazards (Acute and Chronic)
None known health hazard when used as intended in a copy machine.
Carcinogenicity:
NTP?
No
IARC Monographs?
No
OSHA Regulated?
No
Signs and Symptoms of Exposure
Irritation of eyes and respiratory tract may occur in heavy dust conditions.
Medical Conditions
General Aggravated by Exposure
None known.
Emergency and First Aid Procedures
Remove from exposure : wash skin with soap, flush eyes with water, drink water if ingested.
Section VII-Precautions for Safe Handing and Use
Steps to Be Taken in Case Material is Released or Spilled
Vacum or sweep up as with any non-toxic powder.
Waste Disposal Method
Dispose according to federal, state and local environmental regulations.
Precautions to Be Taken in Handing and Storing
Do not store next to strong oxidizers. Eye protection and respirators may be required for bulk handling.
Other Precautions
Avoid excessive exposure to heat.
Section VIII - Control Measures
Respiratory Protection (Specify Type)
None required when product is used as intended.
Ventilation
Local Exhaust
Special
office conditions.
None
Mechanical (General)
Other
normal office conditions.
None
Protective Gloves
Eye Protection
None required when product is used as intended.
None required when product is used as intended.
Other Protective Clothing or Equipment
None required when product is used as intended.
Work/Hygienic Practices
Avoid breathing dust if sample is spilled.
*
N. A. Not Applicable
Unusual Fire and Explosion Hazards
N.A.
(Reproduce locally)
OSHA 174, Sept. 1985
*N. A.
Not Applicable
Section V - Reactivity Data
Stability
Unstable
Conditions to Avoid
Stable
X
No data available
Incompatibility (Materials to Avoid)
No data available
Hazardous Decomposition or Byproducts
None
Hazardous
May Occur
Conditions to Avoid
Polymerization
No data available
Will Not Occur
X
Section VI-Health Hazard Data
Route(s) of Entry:
Inhalation?
Skin?
No
Health Hazards (Acute and Chronic)
Ames Test:Negative
No
Ingestion?
No
Acute oral toxicity(rat): LD50>5000mg/kg
Skin irritation:None irritant
Carcinogenicity:
NTP?
IARC Monographs?
No
No
OSHA Regulated?
No
Signs and Symptoms of Exposure
None
Medical Conditions
Generally Aggravated by Exposure
None
Emergency and First Aid Procedures
Not applicable
Section VII-Precautions for Safe Handing and Use
Steps to Be Taken in Case Material is Released or Spilled
Not applicable
Waste Disposal Method
Shuld be dumped observing all federal, state and local laws.
Precautions to Be Taken in Handing and Storing
To keep the function of the photoconductor, sotre in moderately cool, dark and dry place.
Other Precautions
None
Section VIII - Control Measures
Respiratory Protection (Specify Type)
Not required
Ventilation
Local Exhaust
Not required
Mechanical (General)
Not required
Protective Gloves
Not necessary
Other Protective Clothing or Equipment
Not reqiured
Work/Hygienic Practices
Not reqiured
Special
Not required
Other
Not required
Eye Protection
Not required