WOOD WAGON
SKU# SKY 1713
ASSEMBLY MANUAL
Revised May 2014
The parts and hardware below have been included for assembly:
(A) Wagon Body x 1
(B) Handle x 1
(C) Front Axle x 1
(D) Back Axle x 1
(E) Swivel x 1
(F) Large Bolt x 1
(G) Long Screw x 1
(J) Large Washers x 2
(I) Support Bars x 2
(H) Side Rails x 4
(2 large , 2 small)
(K) Wheels x 4
(L) Wheel Washers x 4
(M) Red Wheel Caps x 4
(N) Cotter Pins x 4
(O) Small Screws x 8
(P) Screw and Capnut x 10
1 Line up the Swivel (E) and the Front Axel (C). Take
1 Large Washer (J) and place on the Swivel face
down, insert the Large Bolt (F) through the aligned
Swivel and Front Axel as shown in the photo.
1a Place the other Large Washer on the bottom of the
Front Axel facing upward and tighten the washer
on the bolt.
2
3
Align four holes of the Swivel with the front holes
of the Wagon Body (A). Then take four Small
Screws (O), insert from the top down and tighten.
Locate Back Axel (D), and line it up with holes on
the back of wagon, take two Small Screws and
insert from the top down and tighten.
3a Place the two Support Bars (I) onto the Back Axel
(one on either side), then align the opposite end of
the supports bars to the holes on the Wagon Body,
use two Small Screws to secure the Support Bars.
4
5
6
Take 1 Wheel (K) and put it onto an axel pole, next
place a Wheel Washer (L) onto the axel pole over
the Wheel. Last place a Cotter Pin (N) to secure
the Wheel and snap a Red End Cap (M) on to the
end of the axel.
Line up the Handle (B) with the Front Axel, then
take the Long Screw (G) and place it through and
tighten.
To secure the Side Railing, align the railing holes
with the holes on the side of the Wagon Body, use
Screw and Capnut (P) to secure. Repeat this step
for all 4 side of the wagon.
WARNING:
1. Do not load more than 200 lbs. on your wagon.
2. Do not over inflate tires.
3. Be extremely cautious when using the wagon on rough terrain,
curbs, or steps ( this is the time when mishandling could cause
damage or bodily in jury).
4. Inspect all parts for sharp edges before using your wagon.
5. Periodically inspect all nuts, bolts, and tires to make sure they are
secure and properly inflated.
6. Do not stand on wagon.
7. Do not use the wagon on an inclined hill.
Manufacturer and seller expressly disclaim any and all liability for
personal injury, property damage or loss, whether direct, indirect, or
incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
Call Us!
We’re here 7 days a week to help you!
(909)-948-8400
Monday-Friday 5:00am-5:30pm pst
Saturday and Sunday 7:00am-3:30pm pst