Sweet Season
Table Set
Designed by: Heidi Pridemore of The Whimsical Workshop
TABLE RUNNER SIZE 47” X 47”
PLACE MAT SIZE 20” X 15”
quiltingtreasures.com | ©quiltingtreasures |
All rights reserved
Pg 1
KIT CALCULATIONS
Table Set
Runner Size: 47" x 47"
Place Mat Size: 20” x 15”
24505 B
24504-X
24508-R
(Includes Runner
Binding)
24506-B
24509-X
24508-B
(Includes Place Mat
Binding)
24507-R
24497-Z
24503-X
(Backing)
12 KITS
YARDS
BOLTS
1½
1
24508-R
(Includes Runner Binding)
7/8
1
24509-X
¼
1
24507-R
½
1
24504-X
1
1
24506-B
½
1
24508-B
(Includes Place Mat Binding)
5/8
1
24497-Z
1/3
1
24503-X
(Backing)
4¾
4
24505-B
Cutting Directions:
Designed by: Heidi Pridemore of The Whimsical Workshop
Note: All strips are cut across the width of the fabric (perpendicular to selvages) unless
noted otherwise.
WOF = Width of fabric from selvage to selvage.
A. 24505 B: Tossed Snowmen – Blue
Table Runner
• Cut one 12 ½” x 48 ½” strip from the length of fabric (LOF).
• Cut one 15 7/8” square from the remaining fabric. Cut the square across one diagonal to make two triangles.
D. 24507-R: Candy Circles – Red
Table Runner
• Cut two 2 ½” x WOF strips. Sub-cut the strips into twenty-four 2 ½” squares.
Place Mats
• Cut two 4 ½” x WOF strips. Sub-cut the strips into sixteen 4 ½” squares.
E. 24504-X: Block Stripe – Multi
Table Runner
• Fussy cut two 4” x 29” LOF strips, each centered on the blue snowmen row.
B. 24508-R: Tinsel – Red Table Runner
• Fussy cut two 4” x 32” LOF strips, each centered on the blue snowmen row.
• Cut one 2” x WOF strip. Sub-cut the strip into two 2” x 12 ½” strips.
Place Mats
• Cut three 2” x WOF strips. Sew the strips together end to end with diagonal seams • Fussy cut four 5 ½” x 20 ½” LOF strips, each centered on the block row.
and cut two 2” x 51 ½” strips.
F. 24506-B: Tossed Candy – Blue
• Cut two 2 ½” x WOF strips. Sub-cut the strips into twenty-two 2 ½” squares.
Place Mats
• Cut six 2 ½” x WOF strips for the binding.
• Cut three 4 ½” x WOF strips. Sub-cut the strips into twenty-four 4 ½” squares.
C. 24509-X: Stripe – Multi
Table Runner
G. 24508-B: Tinsel – Blue
• Cut one 2” x WOF strip. Sub-cut the strip into two 2” x 18” strips.
Place Mats
• Cut eight 2 ½” x WOF strips for the binding.
• Cut one 2” x WOF strip. Sub-cut the strip into two 2” x 19” strips.
quiltingtreasures.com | ©quiltingtreasures |
All rights reserved
Pg 2
Cutting Directions -Continued:
Note: All strips are cut across the width of the fabric (perpendicular to selvages) unless
noted otherwise.
4.
WOF = Width of fabric from selvage to selvage.
Follow Figure 4 and sew the Fabric C strips, Fabric H strips, DD strip, BD strip and
Fabric E strips to adjacent sides of one Fabric A triangle. Trim the resulting block
even with the long side of the Fabric A triangle to make one Corner Block (Fig. 5).
Repeat to make a second Corner Block.
make 2
E
H. 24497-Z: Illusions – Snowflake
Table Runner
• Cut one 1 ½” x WOF strip. Sub-cut the strip into two 1 ½” x 20” strips.
• Cut one 1 ½” x WOF strip. Sub-cut the strip into two 1 ½” x 21” strips.
Place Mats
• Cut four 1 ½” x WOF strips. Sub-cut the strips into eight 1 ½” x 20 ½” strips.
H
E
Backing 24503-X: Snowmen Posters – Multi
Table Runner
• Cut two 55” x WOF strips. Sew together and trim to make one 59” x 66” back.
Place Mats
• Cut two 24” x WOF strips. Sub-cut the strips into four 24” x 19” backs.
C
A
H
C
Fig. 4
Table Runner Assembly:
Sew one 2” x 12 ½” Fabric B strip to each side of the 12 ½” x 48 ½” Fabric A
strip. Sew one 2” x 51 ½” Fabric B strip to the top and to the bottom of the
Fabric A strip to make the Center Block (Fig. 1).
1.
B
Fig. 5
A
B
B
(Refer to Figure 6 while assembling the runner top.)
5.
Center and sew one Corner Block to each long side of the Center Block.
Designed by: Heidi Pridemore of The Whimsical Workshop
B
Fig. 1
2.
Sew six 2 ½” Fabric B squares and six 2 ½” Fabric D squares together,
alternating them, to make one BD strip (Fig. 2). Repeat to make a second BD
strip.
make 2
B
D
B
D
B
D
B
B
D
D B
6.
Layer quilt top, batting and backing; baste, quilt as desired. Trim layers even
with quilt top.
7.
Sew the six 2 ½ x WOF Fabric B strips together, end to end with 45-degree
seams, to make the binding. Fold this long strip in half, lengthwise with wrong
sides together, and press.
8.
Bind as desired.
D
Fig. 2
3.
Finishing:
Sew six 2 ½” Fabric D squares and five 2 ½” Fabric B squares together,
alternating them, to make one DD strip (Fig. 3). Repeat to make a second DD
strip.
make 2
D
B
D
B
D
B
D
B
D
B
D
Fig. 3
quiltingtreasures.com | ©quiltingtreasures |
All rights reserved
Pg 3
Designed by: Heidi Pridemore of The Whimsical Workshop
Fig. 6
quiltingtreasures.com | ©quiltingtreasures |
All rights reserved
Pg 4
ter
mi each
ddl tri
e r ang
ect le
an on
gle th
e
Cen
Place Mat Assembly:
9.
Sew three 4 ½” Fabric F squares and two 4 ½” Fabric D squares together to
make one FF strip (Fig. 7). Repeat to make eight FF strips total.
make 8
F
D
F
D
F
Fig. 7
Finishing:
11. Layer quilt top, batting and backing; baste, quilt as desired. Trim layers even
with quilt top.
12. Sew the eight 2 ½ x WOF Fabric G strips together, end to end with 45-degree
seams, to make the binding. Fold this long strip in half, lengthwise with wrong
sides together, and press. Divide the strip into four equal lengths.
13. Bind as desired.
10. Sew one 1 ½” x 20 ½” Fabric H strip to the top and to the bottom of one
5 ½” x 20 ½” Fabric E strip. Sew one FF strip to the top and to the bottom of
the resulting block to make one Place Mat top (Fig. 8). Repeat to make four
Place Mat tops.
make 4
H
E
H
Designed by: Heidi Pridemore of The Whimsical Workshop
Fig. 8
While all possible care has been taken to ensure the accuracy of this pattern, we are not
responsible for printing errors or the way in which individual work varies.
quiltingtreasures.com | ©quiltingtreasures |
Not For Resale/Winter 2016
All rights reserved
Pg 5