Basketball Kit Installation
BasketBall Pole Box Contents:
Contents Of BackBoard Box:
In the pole box you should have 3 sections of
poles and 3 sets of clamps.
1
1
1
1
1
First Step is to join the 3 sections of pole
together. You will see from the above picture
the 2 pieces with black end stoppers are your
top and bottom pieces of pole. The remaining
piece is the middle section of the whole
BasketBall Pole setup.
x
x
x
x
x
Backboard
BasketBall
Ring
Backing Plate
Bag of screws, brackets and bolts.
Firstly attach the net around the basketball hoop.
You will notice velcro strip either side that joins
over the padded section of the basketball ring.
Attaching the
backing plate to the
backboard.
Fig1
Fig2
Locate the plate as shown
in Fig1.
Then attach securely with a
bolt and washer as shown
in Fig2.
Tighten both bolts
reasonably tight to hold
Fig3 the backing plate in place,
as shown in Fig 3.
In the next Steps we will
attach the ring support to
the front of the backboard.
With the backing plate
securely attached now
attach the 4 double ended
bolts, as show here in this
picture.
Now we are ready to
attach upright pole to the
backboard.
Place the top of the pole in
a similar position as shown
in this picture, and place
the saddles over and locate
over double ended bolts.
Then secure firmly with 4
nuts and washers.
2
Now the remaining steps
are ideally a 2 person
operation, and you will
understand why shortly.
Take the 3 “U“ Bolts and
discard the green plastic
pieces.
Now proceed to push the
“U“ shape clamps through
the net either side of the
blue or pink upright sleeve,
as shown here in the
picture.
Do this at 3 intervals to
clamp to all 3 different
sections of the basketball
pole.
Next place the black spacer
over the u shaped clamp
as shown. This will be the
same on all 3 U shaped
clamps.
Now the 2 person job may
come into play. With one
person holding or pushing
on the clamp from the
inside of the trampoline,
yourself on the outside
place the silver saddle over
the clamp and attach the
nuts as shown.
Then tighten the nuts in
sequence.
From this picture you can
see the direction of which
the ring support needs to
be facing on the front of
the backboard.
Now place the basketball
ring underneath the plate
before securing to the
backboard.
Attach 2 bolts diagonally
to help hold the ring in
place while securing the
remaining 2 sets of bolts.
These secure on the
back of the backboard
with the appropriate
washer and nut.
Simply repeat the
previous process for
the remaining 2
clamps.
You may now start
playing BasketBall.