Installation Guide: Screw to Wall Mirrors
Installation:
1. The easiest way to line up your holes is to place mirror on wall where you are going to install it, and
make the holes with a permanent marker. Make sure not to move mirror during marking otherwise
your holes may not line up. Use timber supports taped to wall to help support mirror while installing
2. For installation on to ceramic tiles it is best to scratch the glazing of the tile prior to drilling so the
drill doesn’t slide on the tiles, to do this use on old drill bit and hammer and gently tap it until the
glazing chips 1 to 2 mm. We recommend the use of Thermodrill for ceramic, marble and porcelain
.
tiles.
3. Drill holes out and insert wall plugs (for ceramic tiles or
masonry) or gyprock mates (for gyprock installation).
Ensure that your plugs are flush with the wall.
Do not use silicone to adhere mirror to wall as this will void
any warranties on the mirror.
4. Place plastic lug into the holes in your mirror.
5. Put mirror in place then screw into the wall
6. Do not over tighten screws; your screw should only be tight
enough so the plastic lug doesn’t spin around. If you over
tighten it, you could cause the mirror to crack.
7. Place chrome cover caps on and clean mirror with mineral
turpentine, place the mineral turpentine onto a rag then rub
surface clean
Installation Guide: Screw to Wall Mirrors
Warranty:
Thermogroup covers all its products with a satisfaction guarantee. In addition Thermogroup will
supply a replacement product where a fault is shown to be caused by manufacture, materials or
workmanship providing the goods have been installed correctly and according to installation
instructions. This guarantee does not include removal, freight or installation costs.
Thermogroup’s products come with guarantees that cannot be excluded under Australian
Consumer Law and you are entitled to a replacement or refund for a major failure &
compensation for any other reasonable foreseeable loss or damage. You are also entitled to have
the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
All of the standard Ablaze Screw to Wall Mirrors have a 1 year warranty. To use the warranty,
repair or service the customer must provide purchase invoice/receipt, and any other relevant
details.
If the product develops a fault within the warranty period due to normal wear and tear, Ablaze
mirrors at its discretion will recognise whether it’s a faulty product or not. If it is impossible or
not economical for the manufacturer to repair the product, the manufacturer will replace the
faulty product with a new unit of the same model or if there is no stock available of the same
model as the product, the manufacturer will replace the product with a new unit of a similar size.
No responsibility can be taken for altered dimensions and lining up of existing holes.
The repair service offered within the warranty period only covers the faults and problem as
developed from the manufacturer’s errors. Any damage caused by improper use or carelessness
or incorrect wiring is not covered
Ablaze Mirrors is not responsible for any monetary loss or injuries caused by improper use of this
product.
Thermogroup Pty Ltd
PO Box 822
LEETON NSW 2705
Tel: 1300 368 631
Fax: 1300 655 532
[email protected]
www.thermogroup.com.au
© Thermogroupau 2014