solidLUUV • recommended
english
weightsetup
Sony rx100 IV
Explosion Drawing
no setup
1. mount your camera
Mount your camera on the cheese plate (d‘ont forget the top ring in between) by
inserting the 1/4-inch screw in the hole (Fig. 2). Your camera must be securely
Top ring
fastened on the rubber part of the cheese plate and the lens must face the same
direction as the nose of the cheese plate (Fig. 3).
Cheese plate
¼ inch screw
Weight cone
screw
2. add additional weights
Small weight ring
Fig. 2
To find out if your camera requires additional weights, refer to the table below. Insert
Weight cone
Position of the ¼ inch screw
on the cheese plate
one or more additional weights to the top funnel or the base cap, and tighten them
(Fig. 1).
Top funnel
Tip
You can insert the small weight ring to either the top funnel or the base cap. In
cases where you do not require additional weight in the top funnel, you can leave
the weight cone screw in the box. The hat-shaped set screw and the rubber washer
need to be inserted every time.
Nose
Camera
Setup type
Additional weight
for the top funnel
Additional weight
for the base cap
Sony RX100 IV
light
-
-
heavy
Weight cone
Small weight ring
Fig. 3
cheese plate
Adjustment ring
Large weight plate
Weightscrews
Small weight plate
Thread nuts
3. Position the weights
Hat-shaped set screw
Refer to the column “position” in the table below to determine the position of the
Rubber washer
weight screws A, B, C & D. With pushing the screws down guide each of them to the
Large weight ring
desired position (1-6), if required.
Base cap
Add the recommended number of small and/or large weights to weight screws A, B,
Fig. 1
C & D and tighten securely using the thread nuts.
A
Camera
Setup type
Sony RX100 IV
B
D
Position
Number of
weights1
Position
Number of
weights1
Position
Number of
weights1
Position
Number of
weights1
light
4
6
1
9
1
16
2
15
heavy
2
4
3
5
1
14
2
10
1
The recommended amount of weight always refers to small weight plates.
Tip
6 small weight plates = 1 large weight plate
community.luuv-stabilizer.com
C
Additional tips
·
The front lens of your 360° camera must face the same direction as the nose of the cheese plate.
·
Make sure your camera is switched on and ready to operate (incl. batteries, memory card, accessories, and if applicable, the zoom set to the correct setting for filming).
·
Sometimes you need to change 1-2 small weight plates to another weight screw or
turn the adjustment ring a few degrees to reach the perfect equilibrium.
·
Watch our tutorial video for this Setup-Guide at community.luuv-stabilizer.com