BUMPER PREP PAD
by
Single-use pre-saturated scuff pad for new unprimed bumpers or
plastic parts.
Benefits
n Reduces steps in bumper preparation processes,
increasing efficiency
n Provides comprehensive abrasion for better paint
adhesion
n Removes water-based and oil-based contaminants
Easy to Use
n DeVilbiss CLEANTM Bumper Prep Pad cleans, abrades and
degreases in one easy step
n Simply soak in water to activate the pad and start prepping your
bumper
Innovative
n The Bumper Prep Pad provides a more consistent scratch pattern and greatly improves paint adhesion
n Additional preparation products may not be needed as the Bumper Prep Pad cleans, abrades, and
degreases in one easy step
With plastic panels and components being an integral part of every modern vehicle,
replacement is often the fastest and most cost-effective route to repair.
New, unprimed bumpers and plastic panels must be
scrupulously clean to ensure optimum adhesion of primers
and sealers.
Any traces of silicones, release agents or greasy deposits as a
result of handling can all result in loss of adhesion.
DeVilbiss Bumper Prep Pads eliminate all those contaminants and
thoroughly abrade the panel, all in one simple step, speeding the
preparation process, ensuring excellent results, eliminating re-work,
maximising efficiency and ultimately profitability.
BUMPER PREP PAD
by
DeVilbiss CLEAN™ Bumper Prep Pad – for perfect
preparation of bumpers and plastic parts
Directions for Use
1. Wear protective equipment to prevent possible skin irritation.
2. Remove all loose contaminates from the surface to be prepped.
3. Submerge Bumper Prep Pad in clean water for approximately 3 seconds
4. Thoroughly abrade the part twice. Re-wet the pad in clean water as
necessary. Do not intentionally rinse/wring cleaning agent from the
Bumper Prep Pad.
5 Do not allow the surface and pad
to dry before thoroughly rinsing
the part with clean water.
6. Repeat the scuffing process as
needed if the part does not appear
uniformly clean and abraded.
Water should not bead on the abraded surface once the
abrasion has been properly completed.
7. Blow dry and wipe down.
8. Discard the Bumper Prep Pad after a single usage.
NOTE: Designed as a single-use scuff pad. Do not use on more
than one bumper or part. The bumper/part to be prepped
does not need to be tempered or prebaked. Clean water
supply is needed.
Part Number
Description
DC-BPP-K12
Box of 12 individually packed Bumper
Prep Pads
Ringwood Road, Bournemouth, Dorset, BH11 9LH
Tel: +44 (0) 1202 571111 Fax: +44 (0) 1202 573488 Email: [email protected]
www.devilbisseu.com