KIT Installation Instructions
Install slides flush onto front edge of left and right spacers, Fig 1
Draw a centerline down the back of outer cabinet, Fig 2
Feed switch and power cable through hole in top of cabinet Fig 3
Center kit back plate to centerline drawn, Fig 4
Fasten back plate with two (2) supplied square drive screws, Fig 5
Install provided 1/4-20 x 1.5" bolts through cabinet top to fasten clevis, Fig 6 + Fig 6-A
Place a 2x4 flat on counter top, Fig 7
Place inner cabinet on top of 2x4, Fig
8
Engage slides on both left and right side evenly , Fig 9
Connect switch and power unit, Fig
10
Depress DOWN button to extend actuator, Fig
11
Fit lower clevis into bottom inner cabinet Fig 12
Install provided 1/4-20 x 1.5" bolts through inner cabinet bottom to fasten clevis, Fig 13
Fasten cover with six (6) supplied square drive screws, Fig 14
Confirming normal operation:
Press the "DOWN" button on the cabinet control switch until the inner cabinet is fully extended
Press the "UP" button on the cabinet control switch until the inner cabinet is fully
retracted
Confirming safety stop operation:
Plug the cabinet into the electrical outlet
Push the "UP" button on the cabinet control switch until the cabinet is retracted fully
Press the "DOWN" button until the cabinet has lowered approximately 3"
Push up on the middle of the inner cabinet. Maintain this force and press the "DOWN" button
The cabinet should not move down in this state
If the safety stop does not prevent the inner cabinet from moving down,
please call customer care at 1-866-866-2888
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 6-A
Figure 7
Figure 8
Figure 9
Figure 10
Figure 12
Figure 11
Figure 13
Figure 14