Base Gel



Very Thin Base Gel
Perfect adhesion for builder gels
Smooth Surface to build the nail on
First step in a three-phase gel system. This thin, clear base gel works as an adhesion
promoter to natural nails.
Usage:
Apply after tip blending, one thin layer of base gel to create maximum adhesion for any
builder gel.
You can use this base gel before applying any builder gel.
Curing time:
2 minutes
Sizes:
15 ml – 28 ml
How to use Builder Gel
1
Builder Gels




High viscosity
Pink Builder Gel
Creates a very natural look on the nail
Does not run into the cuticles
Product description:
Very high viscosity builder gel that does not run into the cuticle while working.
Creates a very natural looking nail.
You can make sculpted nails or tip overlays with this gel.
This product is recommended for advanced nail technicians.
Usage:
 Apply base gel as instructed.
 Apply a thin layer again (Do not cure) and then place an amount of gel in the
middle of the nail bed.
 Work your gel toward the cuticle area and make sure that this product does not
run into the skin. Then spread the gel evenly over the entire nail.
 Cure it for 2.5 minutes.
 Cleanse the nail with Cleanser and a nail wipe or gel sponge.
 Shape and perfect the nail with a 180 grit file.
 Use any top gel to create a high shine on the nail.
 Clean it to remove the sticky residue.
Curing time:
2.5 minutes
Available in:
Clear – Natural – Blue – Pink – Cover Pink – Soft White – White- Soft pink- Ultra white
How to use Builder Gel
2
ONE COLOR MAINTENANCE GEL
Preparation Procedure;
1. Make sure that your table is clean, with Purifiera and set up right.
2. Wash hands of you and your client.
3. Disinfect the hands of you and your client with Purifiera.
4. Remove Nail Polish, using remover with acetone.
5. Gently push back the cuticle with the spoon end of the metal cuticle pusher.
Remove the pterygium with the sharp end of the metal cuticle pusher.
6. Using a 100 gritt file, file the sidewalls straight out from the nail groove and shape
the nail. At this point you also shorten the nail to the desired length.
7. Start filing the old acrylic at the free edge and remove approximately 70%, then
remove the old apex blend the old acrylic into the natural nail and make sure
there are no fill lines.
8. Remove the shine of the natural nail using a 180 grit file.
9. Remove the filing dust from the nail plate using a sanitized implement.
Product;
10. Apply Purifier to cleanse and dehydrate the natural nail.
11. Sparingly apply primer to the natural nail only Allow this coat to dry and then
repeat this again.
12. Using a builder clear, master or all round gel. Apply a thin layer of gel on the
entire nail (Do not cure) Apply gel in the middle of the nail bed, work toward the
cuticle area and spread the gel in the direction of the free edge make sure that
the free edge is sealed. Cure for 2 minutes.
13. Remove the sticky residue with cleanser and a nail wipe.
Shaping;
14. Shape the free edge, the sidewalls and the lower arch. Then begin contour filing
with a 180 grit file start filing at the cuticle area and then work towards the apex
(from the sidewalls to the apex) and then from apex to free edge don’t angle your
file.
15. Apply perfect gloss over the entire nail and make sure that you seal the nail at the
free edge.
16. Remove the sticky residue with cleanser and a nail wipe.
17. Apply Cuticle oil to the cuticle area and massage it into the cuticle.
18. Finish with washing hands of the client.
How to use Builder Gel
3
FRENCH MAINTENANCE GEL
Preparation Procedure;
1. Make sure that your table is clean, with Purifier and set up right.
2. Wash hands of you and your client.
3. Disinfect the hands of you and your client with Purifier.
4. Remove Nail Polish, using remover with acetone.
5. Gently push back the cuticle with the spoon end of the metal cuticle pusher.
Remove the pterygium with the sharp end of the metal cuticle pusher.
6. Using a 100 gritt file, file the sidewalls straight out from the nail groove and shape
the nail. At this point you also shorten the nail to the desired length.
7. Start filing the old acrylic at the free edge and remove approximately 70%, then
remove the old apex blend the old acrylic into the natural nail and make sure
there are no fill lines.
8. Remove the shine of the natural nail using a 180 grit file.
9. Remove the filing dust from the nail plate using a sanitized implement.
10. Apply Purifier to cleanse and dehydrate the natural nail.
11. Sparingly apply primer to the natural nail only Allow this coat to dry and then
repeat this again.
Product;
12. Apply a small amount of Pink or Clear gel over the entire nail (Do not cure)
13. Pick up a ball apply it on the nail bed start working toward the cuticle area in the
direction of the smile line. Create your smile line already in your pink (the other
way around to crate a sharp smile line) Cure for 2 minutes.
14. Apply white gel against the pink and shape the free edge. Cure for 2 minutes. If
necessary repeat this again.
15. Build the nail with clear builder gel.
16. Remove the sticky residue with cleanser and a nail wipe.
Shaping;
17. Shape the free edge, the sidewalls and the lower arch. Then begin contour filing
with a 180 grit file start filing at the cuticle area and then work towards the apex
(from the sidewalls to the apex) and then from apex to free edge don’t angle your
file.
18. Apply perfect gloss over the entire nail and make sure that you seal the nail at the
free edge.
19. Remove the sticky residue with cleanser and a nail wipe.
20. Apply Cuticle oil to the cuticle area and massage it into the cuticle.
21. Finish with washing hands of the client.
How to use Builder Gel
4
NATURAL TIP CLEAR OVERLAY GEL
Preparation Procedure;
1. Make sure that your table is clean, with Purifiera and set up right
2. Wash hands of you and your client
3. Disinfect the hands of you and your client with Purifiera
4. Remove Nail Polish, using remover with acetone
5. Gently push back the cuticle with the spoon end of the metal cuticle pusher.
Remove the pterygium with the sharp end of the metal cuticle pusher
6. Using a 100 gritt file, file the sidewalls straight out from the nail groove and shape
the nail. At this point you also shorten the nail to the desired length
7. Start filing the old acrylic at the free edge and remove approximately 70%, then
remove the old apex blend the old acrylic into the natural nail and make sure
there are no fill lines
8. Remove the shine of the natural nail using a 180 gritt file
9. Remove the filing dust from the nail plate using a sanitized implement
10. Apply Purifier to cleanse and dehydrate the natural nail
Applying tips;
11. Choose the right tip size and make sure that it fit’s from sidewall to sidewall.
12. Blend the well of the tip.
13. Apply glue on the well of the tip and roll the tip on the nail from free edge toward
nail bed.
14. Shorten the tip with a tip cutter to the desired length.
15. Shape and gently blend the tip with a 100 grit file start filing at the free edge and
work toward the nail bed, once you have blended the tip finish by using your 180
grit file.
16. Remove the filing dust from the nail plate using a sanitized implement.
Product;
17. Apply Purifier to cleanse and dehydrate the natural nail.
18. Sparingly apply primer to the natural nail only Allow this coat to dry and then
repeat this again.
19. Using a builder clear, master or all round gel. Apply a thin layer of gel on the
entire nail (Do not cure) Apply gel in the middle of the nail bed, work toward the
cuticle area and spread the gel in the direction of the free edge make sure that
the free edge is sealed. Cure for 2 minutes.
20. Remove the sticky residue with cleanser and a nail wipe.
Shaping;
21. Shape the free edge, the sidewalls and the lower arch. Then begin contour filing
with a 180 grit file start filing at the cuticle area and then work towards the apex
(from the sidewalls to the apex) and then from apex to free edge don’t angle your
file.
22. Apply perfect gloss over the entire nail and make sure that you seal the nail at the
free edge.
23. Remove the sticky residue with cleanser and a nail wipe.
24. Apply Cuticle oil to the cuticle area and massage it into the cuticle.
25. Finish with washing hands of the client.
How to use Builder Gel
5
NATURAL TIP FRENCH MANICURE GEL
Preparation Procedure;
1. Make sure that your table is clean, with Purifier and set up right.
2. Wash hands of you and your client.
3. Disinfect the hands of you and your client with Purifier.
4. Remove Nail Polish, using remover with acetone.
5. Gently push back the cuticle with the spoon end of the metal cuticle pusher.
Remove the pterygium with the sharp end of the metal cuticle pusher.
6. Using a 100 gritt file, file the sidewalls straight out from the nail groove and shape
the nail. At this point you also shorten the nail to the desired length.
7. Start filing the old acrylic at the free edge and remove approximately 70%, then
remove the old apex blend the old acrylic into the natural nail and make sure
there are no fill lines.
8. Remove the shine of the natural nail using a 180 gritt file.
9. Remove the filing dust from the nail plate using a sanitized implement.
10. Apply Purifier to cleanse and dehydrate the natural nail.
Applying tips;
11. Choose the right tip size and make sure that it fit’s from sidewall to sidewall.
12. Blend the well of the tip.
13. Apply glue on the well of the tip and roll the tip on the nail from free edge toward
nail bed.
14. Shorten the tip with a tip cutter to the desired length.
15. Shape and gently blend the tip with a 180 grit file start filing at the free edge and
work toward the nail bed, once you have blended the tip finish by using your 180
grit file.
16. Remove the filing dust from the nail plate using a sanitized implement.
Product;
17. Cleanse and dehydrate the surface of the natural nail.
18. Sparingly apply primer to the natural nail only Allow this coat to dry and then
repeat this again.
19. Apply a small amount of pink or clear gel over the entire nail (Do not cure) Pick
up a ball apply it on the nail bed start working toward the cuticle area in the
direction of the smile line. Create your smile line already in your pink (the other
way around to crate a sharp smile line) Cure for 2 minutes.
20. Using white or extra white gel to make your free edge, place the product and
spread it by using the belly of the brush at this time you also create the smile line.
Cure for 2 minutes.
21. Using a Clear gel over the entire nail, to seal the nail bed with the free edge.
How to use Builder Gel
6
Shaping;
22. Using a 100 grit file to shape the free edge of the nail, and file the sidewalls
straight out from the nail groove finish by angling the file 5 degrees to give the
nail a slight taper, than file the lower arch, with a 180 grit file.
23. Start filing at the cuticle area and than file from both sidewalls in the direction of
the apex with the same motions on both sides. Bevel the nail from apex to free
edge.
24. To remove file demarcations use a buffer and make exactly the same filing
motions to remove all the file demarcations.
25. Apply Cuticle oil to the cuticle area and massage it into the cuticle.
26. Apply 2 coats of top coat with or without UV- blocker to seal the acrylic.
27. Finish with washing hands of the client.
How to use Builder Gel
7
SCULPTING FRENCH MANICURE GEL
Preparation Procedure;
1. Make sure that your table is clean, with Purifier and set up right.
2. Wash hands of you and your client.
3. Disinfect the hands of you and your client with Purifier.
4. Remove Nail Polish, using remover with acetone.
5. Gently push back the cuticle with the spoon end of the metal cuticle pusher.
Remove the pterygium with the sharp end of the metal cuticle pusher.
6. Using a 100 gritt file, file the sidewalls straight out from the nail groove and shape
the nail. At this point you also shorten the nail to the desired length.
7. Start filing the old acrylic at the free edge and remove approximately 70%, then
remove the old apex blend the old acrylic into the natural nail and make sure
there are no fill lines.
8. Remove the shine of the natural nail using a 180 gritt file.
9. Remove the filing dust from the nail plate using a sanitized implement.
10. Apply Purifier to cleanse and dehydrate the natural nail.
Appling form;
11. Place forms under the free edge of the natural nail.
Product;
12. Cleanse and dehydrate the surface of the natural nail.
13. Sparingly apply primer to the natural nail only Allow this coat to dry and then
repeat this again.
14. Apply a small amount of pink or clear gel over the entire nail (Do not cure) Pick
up a ball apply it on the nail bed start working toward the cuticle area in the
direction of the smile line. Create your smile line already in your pink (the other
way around to crate a sharp smile line) Cure for 2 minutes.
15. Using white or extra white gel to make your free edge, place the product and
spread it by using the belly of the brush at this time you also create the smile line.
Cure for 2 minutes.
16. Using a Clear gel over the entire nail, to seal the nail bed with the free edge.
Shaping;
17. Using a 100 grit file to shape the free edge of the nail, and file the sidewalls
straight out from the nail groove finish by angling the file 5 degrees to give the
nail a slight taper, than file the lower arch.
18. Start filing at the cuticle area and than file from both sidewalls in the direction of
the apex with the same motions on both sides. Bevel the nail from apex to free
edge.
19. To remove file demarcations use a buffer and make exactly the same filing
motions to remove all the file demarcations.
20. Apply Cuticle oil to the cuticle area and massage it into the cuticle.
21. Apply 2 coats of top coat with or without UV- blocker to seal the acrylic.
22. Finish with washing hands of the client.
How to use Builder Gel
8