ULTRIMAX 3
TECHNICAL DATA
PRODUCT DESCRIPTION
A two pack Epoxy topcoat ideal for refinishing substrates that are exposed to
chemicals and corrosive substances.
FEATURES
Fast drying times
Easy to apply by brush, roller or spray
Good coverage and has a gloss finish
Excellent water and chemical resistance
RECOMMENDED USE
As a topcoat over an epoxy primer where a durable, high gloss finish is required
PHYSICAL PROPERTIES
Colours:
Full range available including BS, RAL, metallics, sparkles
& special matches, all with lead chromate-free options
Volume Solids:
54.3%
Flash Point:
23ºC
VOC:
386g/litre
Gloss:
Gloss
FILM THICKNESS & SPREADING RATE
SURFACE PREPARATION
Minimum
Maximum
Film thickness, dry
50
60
Film thickness, wet
70
80
Sheet steel
Degrease and abrade steel with P180. If necessary blast
clean to remove millscale, minimum surface preparation
SA2. Apply suitable primer
Aluminium & Galvanised Steel
Apply primer (then other primer if required)
Stainless Steel
Use of primer is required
GRP
Remove release coat, degrease and abrade with P280
Powder Coating
Degrease and abrade with P280
POT LIFE
8 hours at 20ºC (dependant on colour)
SHELF LIFE
12 months in an unopened, original container from date of mixing
APPLICATION METHODS
Brush, Roller or Spray
THINNER / CLEANER:
Ultrimax Epoxy Thinners
DRYING / OVERCOATING
Touch dry:
1 hour
MIXING RATIO
4parts paint – 1part hardener
STORAGE
Store in accordance with national regulations, in a cool, well-ventilated area, away from heat
and ignition. Keep lids tightly closed.
HANDLING
Handle with care. Stir thoroughly before use.
PACK SIZES
5 litre, 20 litre
HEALTH & SAFETY
Please read and observe the safety precautions on the label.
Refer to the material safety data sheets for further information.
Hard dry:
12 hours
To recoat:
minimum 2 hours
maximum 24 hours
The information in this data sheet is correct, to the best of our knowledge, based on laboratory tests and practical experience. However, as the product is used under conditions which are beyond our control, we cannot guarantee
anything but the quality of the product itself. We recommend that users carry out tests to satisfy themselves with the suitability of the product for its intended use. These details are subject to revision from time to time, without notice.
Clayfield Industrial Estate
Tickhill Road
Doncaster DN4 8QG
T. 01302 856666 F. 01302 571510
E. [email protected]
www.ultrimaxcoatings.co.uk