Quality Bathroom Products
Vinni
Oliver
Henry
Rechargeable Battery Powered Mirrors
Battery Mirror
FIXING INSTRUCTIONS
FIXING INSTRUCTIONS.......................................................................2
RECHARGING BATTERY PACK..........................................................3
TROUBLESHOOTING......................................................................5
SERVICE.......................................................................................6
PLASTIC TABS MUST BE REMOVED FROM BATTERY PACK PRIOR TO USE
1.
Position the mirror in a suitable location.
2.
Carefully mark the position of the product using a soft pencil.
3.
Remove the mirror, and mark the positions of the two mounting points.
4.
Using a 10mm masonry drill, drill the holes in the marked positions to a depth of
50mm. If drilling through tiles, use a ceramic drill bit.
5.
Insert the wall-plugs level with the surface of the wall. If fitting to a tiled surface,
wall plugs should be inserted below the surface of the tile to avoid cracking
Ensure that the correct wall fixings are used for the type of surface that is being
drilled into.
6.
Screw the wall hooks into the wall plugs.
7.
Hang the mirror on the wall hooks.
TECHNICAL INFORMATION................................................................6
DISPOSAL....................................................................................6
CONTACT......................................................................................6
INTRODUCTION
Thank you for purchasing this HiB product. Please read through these instructions
carefully and refer back to them during installation to ensure that your product is fitted
correctly and that it retains its high quality finish.
60cm
75cm
This user’s guide contains important information regarding the installation of the
product and the usage of the technical functions. Please read all instructions carefully
to ensure optimal performance. HiB assumes no liability if the instructions in this user’s
guide are ignored!
60cm
60cm
60cm
2
1
2
O
75cm
PACK CONTENTS...............................................................................1
NB. No electrical connection to the mirror is required.
Mirror is suitable for installation in Zone 2 and Outside zones.
2
75cm
INTRODUCTION...............................................................................1
75cm
CONTENTS
2
2
1
Please retain this leaflet for future reference.
225cm
60cm
radius
PACK CONTENTS
Before assembling and operating the Battery Mirror, please check that the contents
are complete. Included in the package:
- Battery Powered Mirror
- Removable Battery Pack
- Battery Charger
- Fixings (2x 10mm wall plugs, 2x 50mm hook screws)
-1-
ZONE
ZONE
1
2
Refers to the area above the bath
or shower up to a height of 2.25
metres and requires a minimum
rating of IPX4 (splash-proof).
Covers an area 0.6 metres
wide immediately next to, and
all round zone 1. Wash basins
should also be treated as zone 2.
The minimum rating here is IPX4.
-2-
2
OUTSIDE
ZONES
Has no special requirements,
unless water jets are likely to be
used for cleaning purposes.
Battery Mirror
RECHARGING BATTERY PACK
1
2
5
6
- For optimum performance, battery
pack needs to be fully drained and
recharged three times.
- Gently push the battery pack into the
mirror until you hear a click.
- Release pressure on the battery pack
and allow it to pop out.
- To recharge the battery, plug the
supplied charger into the larger port
located on the end of the battery pack.
- Only recharge the battery pack
using the supplied charger, and never
charge in the bathroom.
- Once the red LED has turned off, the
battery pack is recharged and ready to
be returned to the mirror.
- Reattach the battery pack to the mirror
by reinserting the wire into the smaller
port on the back of the battery pack.
3
4
7
8
- Gently remove the battery pack from
the mirror.
- Disconnect the battery pack from the
mirror by gently removing the connection
from the end of the battery pack.
- When the red LED turns off and the
battery is fully charged, gently reinsert
the battery pack into its housing and
push until you hear a click.
- Close the flap to protect the battery
pack.
- To turn the mirror on / off, press the
button located on the bottom of the
mirror.
- Locate the flap on the side of the mirror
and lift to reveal the battery pack.
-3-
-4-
Battery Mirror
TROUBLESHOOTING
SERVICE
All of our products are tested for quality, function and electronic safety before delivery.
What do the LEDs mean?
The battery pack incorporates three LEDs: white, red and green. LEDs only light
when the battery pack is plugged into the mains
White LED on: Circuitry functioning correctly
White LED off: Circuitry not functioning correctly - contact supplier
Red LED on:
Red LED off:
Battery charging
Battery fully charged
If you require any further information, or you have questions or concerns about using
our products, please contact your local specialist dealer.
TECHNICAL INFORMATION
Adapter:
240v input, 13v output
LED:
12 x 0.12 watts = 1.44 watts (Oliver)
14 x 0.12 watts = 1.68 watts (Vinni)
14 x 0.12 watts = 1.68 watts (Henry)
Size:
60 x 45cm (Oliver)
70 x 50cm (Vinni)
50 x 80cm (Henry)
Article Number:
73106300 (Oliver)
73106400 (Vinni)
73106500 (Henry)
Green LED on: Transformer functioning correctly
Green LED off: Transformer not functioning correctly - contact supplier
The battery pack isn’t lasting very long
- On a full recharge, the mirror can be illuminated for 25-30 hours.
- For optimum performance and maximum longeivity, the battery pack needs to be
fully discharged and recharged three times.
- Batteries do not have an infinite lifespan. Therefore, after a number of recharges
it may be necessary to replace the rechargable batteries within the battery pack. To
do so, remove the battery pack from the mirror as shown on the previous page. Open
the casing by unclipping the catches on both sides of the casing at the position of
the arrow below. Remove the six batteries and replace them with fresh rechargable
batteries. Replace the casing, and reattach the battery pack to the mirror.
DISPOSAL
With an environmentally-friendly disposal, you can prevent environmental contamination.
Please check on how to dispose of used electronic devices and exhausted batteries in
accordance with local regulations.
Please recycle packaging where possible.
WEEE compliance - must not be mixed with general household waste
CONTACT
HiB Ltd,
Castle House, 21-23 Station Road,
New Barnet, Herts,
EN5 1PH, UK.
-5-
t:
f:
e:
w:
-6-
020 8441 0352
020 8441 0219
[email protected]
www.hib.co.uk
Pdf Supplied By http://www.plumbworld.co.uk/