SIMIX®
SIMIX
All Purpose
Cleaner &
A/C Protective
Coating
Air Conditioning
Refrigeration
Condensing Coils
Air Handlers
Chillers
Cabinets
®
Save Money on Air Conditioning
Lower Your Electric Bill
SIMIX All Purpose Cleaner
• Cleans coils faster
• Will not harm the fin stock
• Runoff will not harm the
environment
SIMIX A/C Protective Coating
• Lowers your energy costs
• Easy to apply
• Units stay cleaner longer
• Longest lasting and most
affordable coating
SIMIX A/C Protective Coating increases CFM’s extends the life of the unit.
ONMENTA
L
VIR
After 30 days, expansion and
contraction cause tiny openings
around fin and tubes. over time,
corrosion begins in these openings.
The corrosion prevents the even
transfer of heat and costs you money.
SIMIX A/C Coating fills in the tiny
openings. SIMIX also significantly
reduces surface tension. This allows
the air to flow through more quickly
and more smoothly, increasing
efficiency. This saves you money.
SIMIX
SIMIX®®–
– Cleaners
Cleaners &
& Coatings
Coatings Since
Since 2004
2004
LY
EN
In a new unit, the fins and
tube stock are tight against
each other.
NANO TECHNOLOGY
FR
I E N D LY
Contains Nano Particles of Titanium Dioxide (TiO2), a photo catalyst
recognized by the EPA as an environmentally biofriendly biocide.
SIMIX® All Purpose Cleaner
& A/C Protective Coating
FAQS
SIMIX A/C Protective Coating
Extending the Life of Your Equipment While Significantly Reducing Your Energy Costs.
SIMIX is nano-engineered, and works in the world of particles that are one thousand times smaller
than the human eye can see. SIMIX contains sub-nano and nano-particles which bind together in a
tight structure. The coating is applied to the condensing coil fins and as it’s sprayed on, it wicks into
the microscopic voids between the fin and tube connection. It fills the voids that are created between
the fin and tube connection during the first 30 days of full operation. It immediately improves heat
transfer between the tube and the fin. The coating is very slick and improves air flow by breaking
surface tension. More air can move through the opening because there is no friction on the fins. The
more CFM pulled through a unit, the more efficient the unit becomes. In most cases, the unit is
restored back to its original specifications.
How do I use SIMIX All Purpose Cleaner and apply SIMIX A/C Protective Coating?
It’s simple. Pull the unit’s breaker. Apply SIMIX All Purpose Cleaner with a misting sprayer. Allow to sit
for a couple minutes. Then thoroughly rinse with water. Replace the unit’s breaker and turn on to dry
for approximately ten minutes. Pull the unit’s breaker again, and then use a high pressure/low volume
sprayer to evenly apply SIMIX A/C Protective Coating over the coils, fins, fans and cabinet. Spray both
sides of coils, fins, fans and cabinet. Spraying the cabinet and supports will extend their life. Replace
the unit’s breaker and run unit for 30 minutes to cure the coating.
How long does SIMIX A/C Protective Coating last?
Depending on your environment, it will last five to seven years. Corrosive environments may require
re-application sooner.
• The first coating to improve heat transfer and air flow
• Extends the life of the condensing coil
• Minimizes salt build-up on coastal installations
• No special training needed to use the cleaner and apply the coating
• Typical ROI is less than 6 months
I
I
I
SIMIX SURFACE SOLUTIONS, LLC 1-800-977-4649 [email protected] www.simixsolutions.com