TruVision NVR 20 / NVR 21 / NVR 50 Hard Drive
Installation Sheet
Installing hard drives in the TVN 20 / TVN 21
Figure 2: Hard drive locations (8 HDD model shown)
/ TVN 50
Caution: Do not insert or remove drives with the TruVision
NVR 20 (TVN 20) / TruVision NVR 21 (TVN 21) / TruVision
NVR 50 (TVN 50) powered on.
Note: This unit contains electrostatic-sensitive components.
Before handling the hard drives, make sure you are properly
grounded to avoid ESD damage.
1.
Unpack the NVR box.
2.
Unpack the NVR HDD box.
6.
1
3
5
7
2
4
6
8
Insert a hard drive into one of the hard drive bays until it
has fully seated into position. Repeat with the rest of the
hard drives.
Figure 3: Insert the hard drive
Note: Hard drives in the shipping box are pre-
mounted with their rail kits/caddy.
3.
Use the key provided in the accessories box to unlock the
front panel.
4
Press the latches on both sides of the front panel to open
it.
Figure 1: Opening the NVR
7.
Close and re-lock the front panel.
Note: The hard drives must be installed BEFORE
powering on the unit. The drives are defaulted to a single
HDD group that is automatically ready to record once IP
cameras are added and configured with recording
schedules.
8. Apply the supplied label on the TVN xxx chassis next to the
original label without covering it. NOTE: Failure to install the
label will affect the warranty of the recorder.
Contact information
5.
Install the hard drives as shown in figure 2. The first drive
in position number 1, the second drive in position number
2, etc. Continue to install all the hard drives in numerical
order.
P/N 1070679C • REV 1.00 • 03MAY13
www.utcfireandsecurity.com, www.interlogix.com or
www.utcfssecurityproducts.eu.
For customer support, see www.interlogix.com/customersupport .
1
© 2013 UTC Fire & Security Americas Corporation, Inc.
Interlogix is part of UTC Climate Controls & Security, a unit of
United Technologies Corporation. All rights reserved.
2
TruVision NVR 20 / NVR 21 / NVR 50 Hard Drive Installation Sheet