Firmware update
Following instructions are meant solely for Papouch devices. Follow instructions step by step.
1) Switch your device into TCP server mode.
2) Before powering the device, shorten the two pins marked red on the Z-SERV connector on Fig.1 below.
Fig. 1 – Z-SERV connector
3) Turn on the device (connect to power source).
4) Run the update software (flasher.exe), click browse and find the firmware file .
Fig. 1 – Update software
5) Now choose the connection type.
„Serial port“ - in case you use SOM port or USB VCP port.
„TCP“ - in case you use Ethernet. Default port number is 10001 (if not changed by user).
6) Push “Start” button to start the update process.
7) After the update is finished, disconnect power from the device.
8) Un-shorten the Z-SERV connector pins.
9) Now the update is done.
www.papouch.com