The
YVE-BIO® Alkaline Pitcher
produces antioxidant alkaline water with a high pH-value.
It removes harmful substances, germs and bacteria and reduces
lime.
Ideally, you fill the pitcher with filtered YVE-BIO® water.
Alkaline water prevents acidosis and therefore promotes good health.
Content and its active
ingredients
Calcium carbonate
Produced in South Korea. The activated charcoal
filters pollutants and causes the intake and
decomposition of toxic substances.
Dechlorinating Ceramics
quickly take up, bind and degrade chlorine and
heavy metals and remove unpleasant odors in tap
water.
Binchotan Charcoal
Absorbs chlorine, heavy metals and other
contaminants and emits far infrared rays during the
water purification process - for clean, healthy and
delicious water.
Fossilized Coral
From a 20-million year old seabed in Korea. It
releases 25% of the mineral content into the water
so that it is soft and mild in taste.
Maifanshi Stones
with superior sterilization effect, release additional
minerals and activate the water to decompose
contaminants.
Brazilian Tourmaline Crystals
Generate electrolysis, produce negative ions and
attract far infrared rays and diffuse them back into
the water.
All components have anti-bacterial properties and
increase dissolved oxygen and ionize water
molecules by decreasing their cluster size. (Nano
Clustering)
The water may be slightly cloudy; these are drinkable minerals that have beneficial properties for your
health.
The filter components should be replaced every 6 months with a daily water consumption of
approximately 1.5 liters,. The lower mineral ring is a little hard to to remove . This is intended to prevent it
from falling against the spout.
First use
1. Take the 3 parts from the container.
Rinse all parts thoroughly under running water.
2. Then place 3 filter components in a pot with a vinegar-water mixture or
a citric acid-water mixture and rinse parts with this solution.
Leave all parts in this mixture for 3 to 5 minutes to start the activation
process.
Rinse everything thoroughly under running water to remove the taste.
3. Put everything back into the pitcher. Fill the pitcher with tap water up to
the filling level (the lower edge of the outlet grille). Allow the filled filter a
further 10 minutes to enable self-activation. Bubbles will rise and the
water may be slightly cloudy. These are drinkable positive minerals.
4. Now your alkaline water is ready to drink.
Cleaning and maintenance
When using the device continuously, a cleaning should be carried out once
every 30 days.
It is not recommended to use common household cleaners.
Rinse everything with either a solution of water and vinegar, or better with a
citric acid-water mixture (half a teaspoon to 3 liters of water - available from
us, see accessories). Rinse it all again with clean water to remove the taste of
vinegar or citric acid.
You do not have to to take out the lower mineral ring during cleaning, simple
rinsing is sufficient.
If you want to interrupt the use (eg because of holidays), clean everything
with the appropriate solution (see recommendation above) and leave all
parts to dry. When restarting, reassemble the clean parts, clean them again
with a citric acid-water mixture, rinse again, fill in water and activate the
device. Wait about 15 minutes to achieve the full effect of the minerals.
Statement of AIT Institut Tulln Österreich
 The pH value is increased.
 Due to the reduction of calcium concentration, the total hardness of
the water is reduced by approximately 20%.
Also, the concentration of hydrogen is reduced by approximately 20%.
 Heavy metals, originating from the pipes and fittings (copper, zinc and
lead), are reduced.