Limited Warranty
Condux International, Inc. extends the following warranty to the original
purchaser of these goods for use, subject to the qualifications indicated:
Condux International, Incorporated warrants to the original purchaser for
use that the goods or any component thereof manufactured by Condux
International will be free from defects in workmanship for a period of one year
from the date of purchase, provided such goods are installed, maintained, and
used in accordance with Condux’s written instructions.
Components not manufactured by Condux International but used within the
assembly provided by Condux International are subject to the warranty period
as specified by the individual manufacturer of said component, provided such
goods are installed, maintained, and used in accordance with Condux’s and
the original manufacturer’s written instructions.
Condux’s sole liability and the purchaser’s sole remedy for a failure of goods
under this limited warranty, and for any and all claims arising out of the purchase and use of the goods, shall be limited to the repair or replacement of
the goods that do not conform to this warranty.
To obtain repair or replacement service under the limited warranty, the
purchaser must contact the factory for a Return Material Authorization (RMA).
Once obtained, send the RMA along with the defective part or goods,
transportation prepaid, to: Condux International, Inc.
145 Kingswood Drive
Mankato, MN 56002
THERE ARE NO EXPRESS WARRANTIES COVERING THESE GOODS
OTHER THAN AS SET FORTH ABOVE. THE IMPLIED WARRANTIES OR
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
LIMITED IN DURATION TO ONE YEAR FROM DATE OF PURCHASE.
CONDUX ASSUMES NO LIABILITY IN CONNECTION WITH THE
INSTALLATION OR USE OF THIS PRODUCT, EXCEPT AS STATED IN
THIS LIMITED WARRANTY. CONDUX WILL IN NO EVENT BE LIABLE
FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Condux International, Inc. • P.O. Box 247 • 145 Kingswood Drive • Mankato, MN 56002-0247 USA
1-507-387-6576 • 1-800-533-2077 • FAX 1-507-387-1442
Internet: http://www.condux.com • e-mail: [email protected]
© Copyright 2009, Condux International, Inc.
Printed in USA
Literature Part Number: 08917089
Revision Number: 2.6
USER GUIDE USER GUIDE USER GUIDE
Reusable Power Eye
Installation Procedure
1.
Remove the specified length of cable jacket, insulation, etc. (See Table 1).
CAUTION: Do not cut into the wire conductors or the pulling eye may fail
prematurely. (Figure 1.)
2.
Slide the sleeve nut over the exposed wire conductors as far as possible.
(Figure 2.)
3.
Spread the wire conductors apart, and insert the tapered plug into the
center. (Figure 3.)
4.
Use an Allen Wrench to screw the tapered plug into the wire conductors,
until it is flush with the ends of the conductors. (Figure 4.)
5.
Use a hammer to close the wire conductors around the tapered plug.
(Figure 5.)
6.
Thread the swivel head, eye socket, or clevis socket firmly onto the sleeve
nut. Attach the pulling eye to a multiple pulling harness or winch line.
(Figure 6.)
Removal Procedure
1.
Use a hacksaw to cut through the wire conductors directly behind the
sleeve nut.
2.
Use a hammer to drive the wire conductors through the sleeve nut and
back into the swivel head, eye socket, or clevis socket.
3.
Remove the swivel head, eye socket, or clevis socket from the sleeve nut
and remove the tapered plug from the wire conductors.
ADVERTENCIA
Instrucciones
de Operación
Figure 1. Figure 2.
Figure 3. Figure 4. Figure 5. Figure 6.
Conductor Size
Pulling Eye Color
2500 kcmil
2000 kcmil
1750 kcmil
1500 kcmil
1250 kcmil
1000 kcmil
750 kcmil
700 kcmil
600 kcmil
500 kcmil 400 kcmil
350 kcmil
250 kcmil
4/0 AWG
2/0 AWG
1/0 AWG Green
Red
Yellow
Black
Blue
Orange
Brown
Gray
Green
Yellow
Black
White
Blue
Green
Black
Red
Remove this Amount of Jacket
51⁄4”
5”
43⁄4”
45⁄8”
41⁄2”
41⁄2”
41⁄4”
33⁄4”
31⁄2”
33⁄8”
31⁄8”
3”
27⁄8”
21⁄2”
21⁄2”
21⁄4”
133 mm
127 mm
121 mm
117 mm
114 mm
114 mm
108 mm
95 mm
89 mm
86 mm
79 mm
76 mm
73 mm
64 mm
64 mm
57 mm
Allen Wrench
Size
⁄16”
⁄16”
5
⁄16”
5
⁄16”
5
⁄16”
5
⁄16”
5
⁄16”
5
⁄16”
5
⁄16”
1
⁄4”
1
⁄4”
1
⁄4”
3
⁄16”
3
⁄16”
3
⁄16”
N/A
5
5
Table 1.
!WARNING: Read and understand all procedure
and safety instructions before using any Condux®
Reusable Power Pulling Eye. Failure to do so may
result in personal injury or property damage. Save
this user’s guide for future reference.
!WARNING: The Condux Reusable Power Pulling
Eye is for cable stringing or pulling only. Do not
use it for any other purpose or severe personal
injury and property damage could result.
!ADVERTENCIA: Favor de leer y comprender todas
las instrucciones de operación y seguridad antes
de usar el Condux® Reusable Power Pulling Eye.
Si Ud. no comprende las instrucciones favor de
consultarle a su jefe.
!WARNING: Do not stand directly behind the pull
string. If any component breaks, severe personal
injury or property damage could result.
!CAUTION: Wear personal protective equipment:
hard hat, safety glasses, safety shoes, and leather
work gloves. Failure to do this could result in
personal injury
!WARNING: Do not exceed the load capacity of the
Condux Reusable Power Pulling Eye or any
element in the pull string. Severe personal injury or
property damage could result.