ENGLISH
Olympus LS-10/11
Phone +45 5120 7860 for support – 7 AM to 7 PM - 7 days a week
v. 3
Olympus LS-10/11 • QuickGuide • dmjx 2010-3
Recording
Use your headphone
1. Slide and hold the POWER button on the left hand side.
2. Press the REC button once (Indicator light will flash)
3. Make a sound check. REC LEVEL is automatically adjusted
4. Press the REC button again (Indicator light is now steady)
5. Press the STOP button to stop the recording.
6. Check your recording.
Turn the power OFF if you are finished.
Play back
Use your headphone
1. Slide and hold the POWER button on the left hand side.
2. Chose with left and right arrow buttons the file you want to listen to.
3. Press the PLAY button.
4. Press the STOP button to stop the play back.
Turn the power OFF if you are finished.
Delete one recording
Delete all recordings
1. Press the LIST buttom and
1. Press the
choose the recording
2. Press the
2. Press the ERASE button
3. Press the
3. Press the up arrow button
(All Erase)
(Erase)
4. Press the
4. Press the OK button
5. Press the
5. Press the LIST button
Turn the power OFF if you are finished.
LIST button
ERASE buttom twice
up arrow button
OK button
LIST button
Telephone Pick-Up
You can use the telephone pick-up for recording a telephone interview
1.
2.
3.
4.
5.
6.
7.
Connect the Pick-Up to the MIC input
Put the Pick-Up in your ear (like a normal ear phone)
Place the loadspeaker of the receiver on top of the telephone Pick-Up
Make a sound check. REC LEVEL is automatically adjusted
Press the REC button again (Indicator light is now steady)
Press the STOP button to stop the recording.
Check your recording.
page 2
Olympus LS-10/11 • QuickGuide • dmjx 2010-3
Inserting batteries
Technical data:
1. Memory: 2 GB (8 GB - LS 11)
2. Rec. time: 3 h 14 m (13 h - LS 11)
3. Battery life: 12 - 15 hours
(alkaline, depending on use)
Insert two AA-size alkaline batteries with correct polarities
You can get new batteries at the radio office.
page 3
Olympus LS-10/11 • QuickGuide • dmjx 2010-3
Recording in complicated sound conditions
Complicated sound conditions is when you have to raise your voice because of
LOUD background noise, e.g. rock concerts, sports stadium, factories, etc.
In order to avoid useless recordings where your voice will be drowned out by
the background noise, set the LS 10/11 to MANUAL recording.
Change recording to MANUAL:
1.
2.
3.
4.
5.
6.
7.
Power on the LS 10/11
Press the MENU botton
Choose REC LEVEL
Press the right arrow
Choose Manual
Press OK twice
Press the MENU botton
Now the LS 10/11 is set to MANUAL REC MODE
Turn the REC LEVEL to 4 (at a start)
Always make a test recording:
Now make a test recording with a distance to the microphone of no more than
10 cm (perhapse less).
Mind the peak level indicator – if the recording is too loud, decrease the REC
LEVEL
Listen via HEADPHONES and check the balance between your voice and the
background noise.
You can experiment with the distance to the microphone and the REC LEVEL in
order to get the best possible ratio between your voice and the background
noise – mind the peak level indicator
IMPORTANT
Please set the LS 10/11 to AUTO REC when finished – otherwise you are giving
the next borrower a hard time concerning the REC LEVEL
page 4