LINK SEAL MODULAR SEAL LS-S316-"V"
(OR APPROVED EQUAL) WITH ONE LINK
MODIFIED FOR A SINGLE MOULDED HOLE
TO SUIT A TRACER WIRE PENETRATION
12 GAUGE TWIN STRANDED
TRACER WIRE THROUGH
PENETRATION SYSTEM
TYPICAL TRACER WIRE DETAIL
AT WATERTIGHT PENETRATION SYSTEM
CONCRETE CHAMBER WALL
INTERIOR CHAMBER WALL
FACTORY CAST OR
CORED WALL OPENING
LINK SEAL MODEL LS-S316
(OR APPROVED EQUAL) WATERTIGHT
SYSTEM c/w S.S. NUTS AND BOLTS.
INSTALL WITH ADJUSTMENT BOLTS
ON INTERIOR SIDE OF CHAMBER.
(SEE NOTE 2)
GROUT EXTERIOR
AFTER WATERTIGHT
SEAL INSTALLATION
EPOXY COATED STEEL
WATERSTOP
100
100
12 GAUGE TWIN STRANDED TRACER WIRE
THROUGH PENETRATION SYSTEM
(SEE DETAIL ABOVE)
PI
PE O.
D.
TO SUI
T LI
NK SEAL I
.
D.(
OR APPROVED EQUAL)
TO SUIT LINK SEAL (OR
APPROVED EQUAL) DIAMETER
REQUIRED FOR CPP PIPE SIZE
MORTAR COATING
FACTORY WELD
CPP WALL PIECE
(AWWA C301)
CONCRETE LINING
STEEL CYLINDER
TYPICAL WALL PIECE WATERTIGHT
PENETRATION SYSTEM - SECTION
NOTE
1. STEEL WATERSTOP TO BE EPOXY COATED.
2. LINK SEAL (OR EQUIVALENT) SYSTEM TO BE INSTALLED WITH ADJUSTING BOLTS MOUNTED TOWARDS THE INTERIOR OF CHAMBER.
LINK SEAL DESIGN TO BE BY MANUFACTURER COMPLETE WITH SHOP DRAWING SUBMITTAL.
3. PIPE MUST BE CENTRED IN WALL OPENING AND SUPPORTED ON BOTH ENDS DURING LINK SEAL (OR EQUIVALENT)
SYSTEM INSTALLATION.
4. FOR TRACER WIRE THROUGH PENETRATION SYSTEM AS DETAILED, A "V" MODIFICATION SHALL BE SPECIFIED FOR A SINGLE LINK
OF THE LINK SEAL (OR EQUIVALENT) SYSTEM, TO ALLOW TRACER WIRE TO PENETRATE THROUGH A MOLDED HOLE.
5. TYPICAL WALL PIECE DETAIL WITH LINK SEAL (OR EQUIVALENT) SYSTEM SHOWN ON THIS DRAWING IS APPLICABLE
FOR PIPE DIAMETERS UP TO AND INCLUDING 1200mm.
PUBLIC WORKS
REV. DATE: APRIL 2014
STANDARD DRAWING
TYPICAL CONCRETE PRESSURE PIPE WALL PIECE
FOR WATERTIGHT SEAL AT PRECAST CHAMBER WALLS
APPROVED BY
DRAWN BY
A.P.
AINLEY GROUP
STD. DWG. NUMBER
SCALE
1-3-4
N.T.S.