DeLaval pulsator HP102
With adjustable pulsation rate and ratio
Reliability – Controlled Flexibility – Stability
The pulsator is in many respects the most important part of
your milking plant. It must maintain a constant pulsation rate
and ratio, regardless of temperature, humidity and other
factors. Based on its well proven design, DeLaval pulsator
HP102 has features which give optimal performance, high
reliability and maximal durability.
DeLaval pulsator HP102 has an adjustable pulsation rate to
fit vacuum conditions in the milking plant. It is
manufactured in tough, long lasting materials and works
without the need of electricity.
www.delaval.com
Pulsation rate and pulsation ratio
Constant intervals between the changes in pressure are
important to ensure rapid milking and good udder health.
These changes are governed by the pulsation rate.
The relationship between the length of the suction and the
massage phase is an important factor for ensuring optimal
teat treatment. This relationship is determined by the
pulsation ratio. By replacing the pulse slide, other pulsation
ratios can be achieved.
DeLaval pulsator HP102 assures constant pulsation rate and
ratio to give you maximal milking performance
Adjustable rate and ratio
Adjustable pulsation rate
The pulsator must consistently maintain the same rate,
delivering the same number of pulses each minute.
DeLaval pulsator HP102 is supplied pre-adjusted to give 60
ppm at 50 kPa. If a lower installation vacuum is used, the
pulsator can be re-adjusted to give the same pulsation rate.
Deviation can be adjusted by turning the spindle. This
adjustment should be made by a DeLaval service engineer.
Installations
Bucket milking installation
Most importantly, the DeLaval pulsator HP102 functions
without electricity. This allows for easy installation, safe
execution and the flexibility to perform under all
environments and conditions.
Data
DeLaval pulsator HP102
Pulsation rate:
Pulsation ratio:
Ambient temp:
Weight:
Start vacuum:
60 ppm adjustable
65/35
alt. 70/30
alt. 60/40
alt. 50/50
max. +550C
400 g
27 kPa
Pipeline milking installation
Printed on environmentally friendly paper.
DeLaval is a trademark of the DeLaval Group.
The manufacturer reserves the right
to make design changes. 11691-en/0105