MOUNTING TEMPLATE
HD810 DOME CAMERA
PRINTING INSTRUCTIONS
MOUNTING INSTRUCTIONS
To print this document, you can right-click the screen, and
then click print to print from your browser. You can also
download the document to your computer, open it in Adobe
Reader or another program, and print using that program.
Once you have printed the mounting template, follow these
instructions to drill holes for your camera.
1. Cut around the outer circle of the camera template.
2. Tape the template to the location you want to mount
your camera.
Make sure you select the option to print this document
at its actual size. Failure to do so may result in an
incorrect size for this template.
3. If you want to route the cable through a wall or ceiling,
use a 7/8” bit to drill a hole for the cable connector.
To confirm that you have printed at actual size, use the ruler
graphic below. Each division on the graphic should be 1 inch
in length when measured with a ruler or measuring tape.
4. If you are using the plastic anchors to mount the
camera, use a 3/16” bit to drill a hole through the paper
and wall or ceiling for the plastic anchors.
5. If you are mounting directly to wood or into a stud,
use a 1/16” bit to drill a pilot hole for the included
screws through the paper and wall or ceiling.
EACH SECTION OF THE RULER GRAPHIC
6. Remove the template from the location.
SHOULD MEASURE 1 INCH WHEN THIS
7. Insert the plastic anchors into the smaller holes.
DOCUMENT IS PRINTED
8. Follow the installation instructions included with your
camera.
4 5/8” Diameter
(camera w/dome)
3/16” (4mm) hole
1 5/8” (41mm)
PLEASE CONFIRM EACH SECTION OF
THE RULER GRAPHIC MEASURES 1 INCH
4 9/16” (122mm) Diameter
(camera w/paintable cover)
7/8” (22mm) hole for
cable (optional)
3/16” (4mm) hole
(for included anchor)
(for included anchor)
3/16” (4mm)
3/16” (4mm)
1 13/16” (46mm)
distance between mounting holes (on center):
3 11/16” (93mm)
base diameter: 4 7/16” (112mm)
32410AF