2 SQUARE MIRROR
WALL
Assembly instructions
Y503-10123
rev 0.1
accordance with National Electric Code and local regulation: To assure full compliance with local codes and regulations,
check with your local electrical inspector before installation. This equipment is guaranteed only when used as indicated
before carrying out any connection or maintenance operations.
YOUR BOX SHOULD CONTAIN
X2
Wall bracket
Mirror
X2
#8 countersunk screws
strain relief
J-box
cover plate
STEP 1.
1. Install the brackets on the wall with screwsand appropriate anchoring.
(screws and anhors not included) Do not omit any holes on the brackets.
2. The brackets should be installed 4 inch below
the top of the mirror
MIRROR
SIZE
X
A
DIMENSION
X
15”
B
15”
C
22”
D
15”
4’’
1.2
STEP 2.
1. Make the appropriate electrical connections.
2. Install the cover plate with the screws provided.
3. Snap the strain relief on the wire next to the J-box
cover exit and push it into the cover hole
2.1
2.3
2.2
FOR 0-10V DIMMABLE
VERSION*
FIXTURE
WIRES
CEILING
WIRES
GREEN
GREEN
BLACK
BLACK
PURPLE +
WHITE
WHITE
GREY -
FIXTURE
WIRES
CEILING
WIRES
0-10VDC +
DC -
* PHASE DIMMING DO NOT
REQUIRE ADDITIONNAL WIRES
Artemide inc.
250, Karin Lane , Hicksville, NY 11801
T. +1 631 694 9292 | [email protected] | www.artemide.net
Artemide Ltd.
11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4
T. +1 514 323 6537 | [email protected] | www.artemide.net
1
Assembly instructions
Y503-10123
rev 0.1
2 SQUARE MIRROR
WALL
STEP 3.
1. Hang the mirror on the wall by lining up the brackets to the corresponding slots behind the mirror.
Side view
Wall
Mirror
STEP 4.
Only if you have the fluorescent option
1. Pull out diffusers
4.1
2-3. insert lamping
4. Replace diffusers
4.4
4.3
4.2
Artemide inc.
250, Karin Lane , Hicksville, NY 11801
T. +1 631 694 9292 | [email protected] | www.artemide.net
Artemide Ltd.
11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4
T. +1 514 323 6537 | [email protected] | www.artemide.net
2