P/N 1122194 Rev. B
Installation Instructions - ProTrap® Conversion to SMART2™
2
1
Item Part #
Description
1. 1122064 Solenoid Cover Assembly ProTrap® SMART2™
2. 1704312 Motor-Reversing Solenoid - 3 Pt. Mt.
STEP 1:
Disconnect power to ProTrap®. Remove existing gray
cover and RF solenoid from ProTrap® intermediate
bracket.
SCREWS NOT
SHOWN FOR
CLARITY
STEP 2:
Install solenoid 2 onto ProTrap® intermediate bracket.
Fasten with #10 x 1/2” cap screws.
PROTRAP®
INTERMEDIATE
BRACKET
ENCODER WIRES
FROM MOTOR
PROTRAP®
INTERMEDIATE
BRACKET
RF SOLENOID
2
#10 X 1/2”
CAP SCREW
EXISTING
GRAY COVER
Installation Instructions - ProTrap® Conversion to SMART2™ - continued
STEP 3:
Connect wires from ProTrap® bracket to solenoid and from gray solenoid cover to solenoid as shown below.
WIRE FROM
BATTERY
NEGATIVE
WIRES (BLACK)
OPENING
ROTATION IS
CLOCKWISE
PROTRAP®
INTERMEDIATE
BRACKET
CONNECT QUICK
DISCONNECTS OF
RED & BLACK WIRES
POSITIVE WIRES
(RED STRIPE)
SOLENOID COVER
BLACK WIRE W/
RING TERMINAL
YELLOW WIRE
STEP 5:
PROTRAP®
INTERMEDIATE
BRACKET
WIRE FROM
BATTERY
CONNECT QUICK
DISCONNECTS OF
RED & BLACK WIRES
NEGATIVE
WIRES (BLACK)
POSITIVE WIRES
(RED STRIPE)
OPENING
ROTATION IS
COUNTERCLOCKWISE
SOLENOID
SHOWN
UNMOUNTED
FOR CLARITY
SOLENOID
SHOWN
UNMOUNTED
FOR CLARITY
STEP 4:
P/N 1122194 Rev. B
SOLENOID COVER
RED WIRE W/RING
TERMINAL
BLACK WIRE W/
RING TERMINAL
GREEN WIRE
NOTE: Swap green and
yellow wires to reverse
motor direction.
YELLOW WIRE
GREEN WIRE
Reconnect power to ProTrap ®. Pair (introduce)
SMART2™ remote to ProTrap® as shown in remote
instructions (P/N 1122198) and verify operation.
Replace solenoid cover and secure with #10 x 1/2” cap
screws as shown at right.
RED WIRE W/RING
TERMINAL
PROTRAP®
INTERMEDIATE
BRACKET
BEND RING
TERMINALS UP
BLACK WIRE W/RING
TERMINAL TO NEGATIVE
SOLENOID POST
#10 X 1/2”
CAP SCREW
SOLENOID COVER
RED WIRE W/RING
TERMINAL TO POSITIVE
SOLENOID POST