iSoftPhone
at Your
Fritz!Box
in 8 Steps
Step ONE
•
POTS / ISDN / VoIP
Install your Fritz!Box
for your telephone
mainline
Step TWO
Make sure you can
make a call with a
phone connected to
your Fritz!Box
Step THREE
•
Download and Install:
iSoftPhone
for your Mac
your iPad
and / or
your iPhone
Step FOUR
Make sure your Mac,
iPad or iPhone are
within the same LAN/
WLAN, as your Fritz!
Box
Step FIVE
•
•
In your Fritz!Box config, add a new phone
Do choose LAN/WLAN (IP-Telephone)
Step SIX
•
•
•
Do set a Password here
Do make a note of those 3 parameters
Just finish the „installation“ of a phone on your
Fritz!Box
Step SEVEN - MAC
•
•
•
•
Please start iSoftPhone
Go to Settings / My SIP
Do enter the 3
parameters you have just
noted.
Do not forget to activate
the new settings.
You do not need to change any other settings at all !
Step SEVEN - iPad/iPhone
•
•
•
Please start iSoftPhone
Go to Connection
Settings
Do enter the 3
parameters you have just
noted.
You do not need to
change any other
settings at all !
Step EIGHT
Let‘s go ... have your 1st
phone call!
Just in case....
Please follow the procedure
and check the settings!
Pretty often, instead of entering
the name of the Fritz!Box you
will need to enter its IPAddress (LAN/WLAN) here.
PLEASE DON‘T!
If you are using a SIP-Provider
(VoIP) for your main line...
Do ONLY configure the Fritz!Box to
connect with your SIP-provider.
Configure iSoftPhone as described in
this manual.
DO NOT configure iSoftPhone with
the data/credentials you received from
your SIP-provider!