COMBINATION INSTALLATIONS
Revised 09/12/14 Page 1/2
Document # PGCI-019
Drop-In Cooktop/
Single Wall Oven
Y
INAR
WARNING
All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated
M
PRELI
PLANNING
GUIDE
•
Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
•
All appliances must be installed in accordance with the
accompanying installation instructions.
NOTE: When installing a gas cooktop, the width of the cooktop
must be equal to or wider than the wall oven width.
All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated
Combustible material,
non-combustible material
recommended
C
NOTE: See following page for dimension key and notes.
B
Cutout depth
Non-combustible material
Drop-in cooktop, approved models:
DCT, ETT, MET, RGC, RNCT
or SGM series only
Dacor DTO[V], DYO[V] or RNO[V]
series single wall oven
D
E
Front of countertop
Cabinet face
*
A
Minimum from
finished
countertop to
oven platform
36"
(91.4 cm)
typical
counter height
Wall oven
platform,
see wall oven
planning guide
24" (61.0 cm)
Minimum interior cabinet depth
Cabinet face
*DYO series only: 1" (2.5 cm) min.
CUTAWAY SIDE VIEW
All specifications subject to change without notice.
www.dacor.com
Phone: (800) 793-0093
COMBINATION INSTALLATIONS
Revised 09/12/14 Page 2/2
Document # PGCI-021
Drop-In Cooktop/
Single Wall Oven
Cooktop/Wall Oven
Model No.
A Min.
B
C Min.
D Min.
E Min.*
DCT series cooktop
with DTO[V] wall oven
30 7/8”
(78.4 cm)
19 5/8”
(49.8 cm)
3 1/4”
(8.3 cm)
1 5/8”
(4.1 cm)
3/4”
(1.9 cm)
DCT series cooktop
with DYO[V] wall oven
31 3/4”
(80.6 cm)
19 5/8”
(49.8 cm)
3 1/4”
(8.3 cm)
1 5/8”
(4.1 cm)
3/4”
(1.9 cm)
DCT series cooktop
with RNO[V] wall oven
30 7/8”
(78.4 cm)
19 5/8”
(49.8 cm)
3 1/4”
(8.3 cm)
1 5/8”
(4.1 cm)
3/4”
(1.9 cm)
ETT, MET series cooktop
with DTO[V] wall oven
32 5/8”
(82.8 cm)
19 3/4”
(50.2 cm)
2 1/4”
(5.7 cm)
1”
(2.5 cm)
1”
(2.5 cm)
ETT, MET series cooktop
with DYO[V] wall oven
33 1/2”
(85.1 cm)
19 3/4”
(50.2 cm)
2 1/4”
(5.7 cm)
1”
(2.5 cm)
1”
(2.5 cm)
ETT, MET series cooktop
with RNO[V] wall oven
32 5/8”
(82.8 cm)
19 3/4”
(50.2 cm)
2 1/4”
(5.7 cm)
1”
(2.5 cm)
1”
(2.5 cm)
RGC series cooktop
with DTO[V] wall oven
30 7/8”
(78.4 cm)
19 3/4”
(50.2 cm)
2 7/8”
(7.3 cm)
1 7/8”
(4.8 cm)
3/4”
(1.9 cm)
RGC series cooktop
with DYO[V] wall oven
31 3/4”
(80.6 cm)
19 3/4”
(50.2 cm)
2 7/8”
(7.3 cm)
1 7/8”
(4.8 cm)
3/4”
(1.9 cm)
RGC series cooktop
with RNO[V] wall oven
30 7/8”
(78.4 cm)
19 3/4”
(50.2 cm)
2 7/8”
(7.3 cm)
1 7/8”
(4.8 cm)
3/4”
(1.9 cm)
RNCT series cooktop
with DTO[V] wall oven
32 3/8”
(82.2 cm)
19 3/4”
(50.2 cm)
1 1/8”
(2.9 cm)
2 3/4”
(7.0 cm)
2 3/4”
(7.0 cm)
RNCT series cooktop
with DYO[V] wall oven
33 1/8”
(84.1 cm)
19 3/4”
(50.2 cm)
1 1/8”
(2.9 cm)
2 3/4”
(7.0 cm)
2 3/4”
(7.0 cm)
RNCT series cooktop
with RNO[V] wall oven
32 3/8”
(82.2 cm)
19 3/4”
(50.2 cm)
1 1/8”
(2.9 cm)
2 3/4”
(7.0 cm)
2 3/4”
(7.0 cm)
SGM series cooktop
with DTO[V] wall oven
30 7/8”
(78.4 cm)
19 3/4”
(50.2 cm)
2 7/8”
(7.3 cm)
1 7/8”
(4.8 cm)
3/4”
(1.9 cm)
SGM series cooktop
with DYO[V] wall oven
31 3/4”
(80.6 cm)
19 3/4”
(50.2 cm)
2 7/8”
(7.3 cm)
1 7/8”
(4.8 cm)
3/4”
(1.9 cm)
SGM series cooktop
with RNO[V] wall oven
30 7/8”
(78.4 cm)
19 3/4”
(50.2 cm)
2 7/8”
(7.3 cm)
1 7/8”
(4.8 cm)
3/4”
(1.9 cm)
PLANNING
GUIDE
Notes
Provide ventilation through cabinet, 7 square
inches minimum. Location may vary.
Minimum 2 inches of space between front of
chassis and back of cabinet required, below
counter-top. See RNCT Planning Guide.
Cooktop model SGM464GG is not approved for
this application.
*Based on a front cabinet thickness of 3/4” (7.0 cm)
All specifications subject to change without notice.
www.dacor.com
Phone: (800) 793-0093