E
W WARNING –
DROWNING HAZARD
Infants have DROWNED in infant bath tubs. ALWAYS keep
infant within adult’s reach. NEVER lift this product with infant
in it. NEVER place this product in water in an adult bath
tub or sink. ALWAYS keep the drain open in the adult bath
tub or sink. Infants can drown in as little as 1 inch of water.
ALWAYS bathe your infant using as little water as necessary.
NEVER allow other children to substitute for adult supervision.
Discontinue use of the product if it becomes damaged,
broken, or disassembled.
3. For POSITION 1, push the flexible basin down only at the end opposite the
hook. Rotate the metal brace away from the leg towards the underside of the
basin and position brace into slot on bottom of basin.
4. For POSITION 2, disengage the brace and rotate it back into its storage
position. Push the flexible basin down until all sides are fully extended.
IMPORTANT:
DO NOT push down while the brace is engaged as this will result in damage to
the brace.
Basin
Drain Plug
5. Make sure the basin’s drain plug is securely fitted into the drain hole before
filling the tub.
6. Fill the tub with the minimum amount of water to a level that is well below
baby’s neck. Always test the water temperature and water level before placing
your baby into the tub.
IMPORTANT:
NAKED was designed with a large range of children in mind. If you find your child
slipping in the recline position, it may be beneficial to place a small towel or sponge at
the bottom of the tub.
Leg
Metal Brace
W WARNING:
Slot
Hook
Naked can be used in two different positions, depending on the age of your child.
POSITION 1 - NEWBORNS
THE RECLINE POSITION IS
INTENDED FOR NEWBORNS.
THIS POSITION CREATES A
SMALL BASIN FOR NEWBORNS,
HELPING KEEP THEIR HEAD
ABOVE WATER.
POSITION 2 - INFANTS TO TODDLERS
THE FULLY EXPANDED BASIN
POSITION IS INTENDED FOR
BABIES WHO ARE ABLE TO SIT
UPRIGHT UNASSISTED.
The typical water temperature for bathing a baby should be
between 90 and 100°F (32.2 and 37.8°C). Infants can drown in
as little as 1 inch of water; ALWAYS bathe your infant using as
little water as necessary.
7. After bathing and removing your baby from the tub, drain water
from the tub by lifting the drain plug, and rotating to the side.
Tilt the tub to drain water.
8. Once the tub has completely drained, turn it upside down on a flat surface and
push down on the flexible bottom until it is fully collapsed.
9. If using POSITION 1, rotate the brace back towards the leg and
lock it into place.
10.To collapse legs, place one hand on the bottom of the tub and with the other
pull the center of the leg upward to release from the locked position and Fold
leg inward toward the center of the tub.
1. Place tub upside down and unfold both support legs outward until they snap into
their locked positions. Turn the tub right side up.
2. Set the tub on flat, level surface, such as the bottom of a bathtub or the floor.
IMPORTANT:
• Make sure the tub is standing right side up and the basin has
been put into the recline position before pivoting the metal
support brace into the slot on the bottom of the basin. If the
support brace is put into place while the product is upside
down or before the basin has been put into the recline
position, the metal support brace may not lock into the slot
properly. Gravity and weight help keep the brace in place.
• Always double check that the brace is securely in place
before putting your child into the tub.
W WARNING:
Never use the tub on a raised surface. Always keep the drain
open in an adult bathtub or sink when using the tub.
IMPORTANT:
DO NOT try and rotate leg without pulling upward first as this may damage the locking
mechanism.
11. Rotate hook out and hang to dry.