TOUGH STUFF ST7200 WATER BASE MASONRY & BRICK STAIN MSDS
May be used to comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be consulted for specific requirements.
HMIS: Health 1, Flammability 0, Reactivity 0, Protection B
Section I
MANUFACTURER’S INFORMATION
Manufacturer’s Name & Address:
Pro Coatings, Inc.
233 1⁄2 Prospect Street
Sparta, MI. 49345
Section II
Telephone Number for Information: 616-887-8808
EMERGENCY CONTACT: CHEMTREC 800-424-9300
Date Prepared: September 2003
MATERIAL IDENTIFICATION AND INFORMATION
Hazardous components – Chemical Name & Common Names
(Hazardous Components 1% or greater; Carcinogens 0.1% or greater)
Titianium Dioxide
Hydrous Magnesium Silicate
Zinc Oxide
Diatomaceous Earth,
Flux Calcined
CAS #
%
13463-67-7
14807-96-6
1314-13-2
58855-54-9
20
5
5
OSHA
PEL (ppm)
ACGIH
TLV (ppm)
10mg/M3
2mg/M3
10mg / M3
2mg / M3
5mg / M3
10mg / M3
OTHER
LIMITS
No toxic chemical(s) subject to the reporting requirements of section 313 of Title III and of 40 CFR 372 are present.
D.O.T. Shipping Information: Non-hazardous
Section III
PHYSICAL / CHEMICAL CHARACTERISTICS
1) BOILING POINT:
2) SPECIFIC GRAVITY (H2O=1):
3) VAPOR PRESSURE (mm Hg):
4) MELTING POINT:
5) VAPOR DENSITY (Air = 1):
6) EVAPORATION RATE:
7) SOLUBILITY IN WATER:
8) WATER REACTIVE:
9) APPEARANCE & ODOR:
10) COATING VOC:
Section IV
FIRE AND EXPLOSION DATA
1) FLASH POINT & METHOD:
2) AUTO-IGNITION TEMPERATURE:
3) FLAMMABILITY LIMITS IN AIR % BY VOLUME:
4) EXTINGUISHER (MEDIA):
5) SPECIAL FIRE FIGHTING PROCEDURES:
6) UNUSUAL FIRE AND EXPLOSION HAZARDS:
Tough Stuff Architectural Coatings
N/A
1.32
N/A
N/A
<1 / Lighter than air
<1 / Slower than Ether
Dilutable
N/A
Viscous liquid; Mild odor
.095 Pounds/Gallon
N/A
N/A
LEL: N/A UEL: N/A
Foam, Alcohol Foam, CO2, Dry Chemical
N/A
Product will not burn but may spatter if temperature exceeds
the boiling point of water. Dried solids can burn.
Tough Stuff ST7200 Masonry & Brick Stain Material Safety Data Sheet • 33
Section V
REACTIVITY DATA
1) STABILITY:
2) CONDITIONS TO AVOID:
3) INCOMPATIBILITY (Materials to Avoid):
4) HAZARDOUS DECOMPOSITION PRODUCTS:
5) HAZARDOUS POLYMERIZATION:
Section VI
Stable
None Known
None Known
Burning of dried solids may give off oxides of carbon and nitrogen.
Will Not Occur
HEALTH HAZARD DATA
1) PRIMARY ROUTES OF ENTRY:
Inhalation: N/A
Skin Absorption: N/A
Ingestion: N/A
2) CARCINOGEN LISTED IN:
NTP: No
IARC Monograph: No
OSHA: No
3) HEALTH HAZARDS:
ACUTE: None known
CHRONIC: None known
4) SIGNS AND SYMPTOMS OF EXPOSURE:
INHALATION: May contain products that will irritate mucous
membrane and respiratory tract. Inhalation may produce
symptoms of headache and nausea in poorly ventilated areas.
SKIN CONTACT: Prolonged contact may produce temporary
reddening of skin.
EYE CONTACT: Direct contact may cause eye irratation.
INGESTION: No evidence of adverse effects.
5) MEDICAL CONDITIONS GENERALLY
AGGRAVATED BY EXPOSURE:
None known
6) EMERGENCY FIRST AID PROCEDURES:
See items 7 through 10 below.
7) EYE CONTACT:
Immediately flush eyes with water.
8) SKIN CONTACT:
Wash effected areas with soap and water.
9) INHALATION:
No emergency care anticipated
10) INGESTION:
No harmful effects expected.
Section VII
CONTROL AND PROTECTIVE MEASURES
1) RESPIRATORY PROTECTION (Specify type):
Use a NIOSH approved dust / mist respirator when spraying
2) PROTECTIVE GLOVES:
Vinyl or neoprene
3) EYE PROTECTION:
Safety glasses
4) VENTILATION TO BE USED:
a. Local exhaust: Recommended
b. Mechanical (General): N/A
5) OTHER (Specify):
N/A
34 • Tough Stuff ST7200 Masonry & Brick Stain Material Safety Data Sheet
Tough Stuff Architectural Coatings
Section VIII
PRECAUTIONS FOR SAFE HANDLING AND USE/LEAK PROCEDURES
1) STEPS TO BE TAKEN IF MATERIAL
IS RELEASED OR SPILLED:
Restrict area to personel needed. Major spills should be
collected for disposal. Small spills may be flushed to sewer if
permitted by federal, state and local regulations.
2) WASTE DISPOSAL METHODS:
Incinerate or bury in a suitable landfill as permitted by
government regulations.
3) ENVIRONMENTAL IMPACT:
N/A
4) PRECAUTIONS TO BE TAKEN IN
HANDLING AND STORING:
Use with adequate ventilation. Avoid contact with skin and
clothing. Avoid breathing spray mist.
The information in this MSDS was obtained from sources which we believe are reliable. HOWEVER, THE
INFORMATION IS PROVIDED WITHOUT ANY WARRANTY, EXPRESSED, OR IMPLIED, REGARDING ITS
CORRECTNESS. The conditions or methods of handling, storage, use and disposal of the product are beyond
our control, and may be beyond our knowledge. FOR THIS AND OTHER REASONS, WE DO NOT ASSUME
RESPONSIBILITY AND EXPRESSLY DISCLAIM LIABILITY FOR LOSS, DAMAGE, OR EXPENSE ARISING
OUT OF OR IN ANY WAY CONNECTED WITH THE HANDLING, STORAGE, USE, OR DISPOSAL OF THE
PRODUCT. This MSDS was prepared and is to be used only for this product. If apprised of changes, updated
MSDS sheets will be promptly issued. Users must make their own determination regarding the suitability of the
product for their own purpose prior to use.
Tough Stuff Architectural Coatings
Tough Stuff ST7200 Masonry & Brick Stain Material Safety Data Sheet • 35