ROTOR BEARING SUPPORTS FOR WIND TURBINES Asymmetric Spherical Roller Bearings ROTOR BEARING SUPPORTS FOR WIND TURBINES Asymmetric FAG spherical roller bearings Reliable rotor bearing supports As a development partner to the wind turbine industry, we have been producing bearing supports for this sector for over 30 years. In partnership with our customers, we develop the most efficient bearing support for every application. The rotor shaft bearing support is of central importance in wind turbines. This is where all the forces act that are induced by the wind. Profiled rolling elements with Triondur C coating Rigid central rib FAG spherical roller bearings are suitable for extremely heavy loads. We have consistently further developed this proven bearing solution in order to increase the operating life even further. Product features •Asymmetric contact angle •Adjusted internal clearance •Profiled rolling elements Asymmetric contact angle •Rigid central rib Adapted bore diameter •Rolling elements coated with Triondur C •Identical dimensions to standard bearings •Inner ring matched to suit the shaft for reconditioning ROTOR BEARING SUPPORTS FOR WIND TURBINES 3.Increased robustness due to lower key wear values Customer benefits •Longer operating life •Interchangeable with standard bearings •Reduced overall operating costs (TCO) 1 Axial forces 70 % Symmetric with floating central rib 60 % Time proportion 2.Increased robustness due to further decrease in the contact pressure Symmetric with floating central rib Symmetric with fixed central rib Asymmetric with fixed central rib 50 % Symmetric with fixed central rib 40 % Asymmetric with fixed central rib 30 % 20 % 10 % 2 0 % Contact pressure Symmetric with floating central rib Asymmetric with fixed central rib Key wear value [p*v] combined radial and axial load Technical advantages 1.Reduced vibrations in the drive train due to increased axial rigidity Axial displacement Asymmetric design for even higher axial load carrying capacity The asymmetric spherical roller bearing has a larger contact angle on the bearing row subject to axial loads and a smaller contact angle on the bearing row subject only to radial loads. 3 -80 -60 -40 -20 0 Roller length 20 40 60 80 OSP / D-D / 201510.2 / Printed in Germany by wünsch Schaeffler Technologies AG & Co. KG Georg-Schaefer-Strasse 30 97421 Schweinfurt Germany Internet www.schaeffler.de/en [email protected] www.schaeffler.de/windpower Every care has been taken to ensure the correctness of the information contained in this publication but no liability can be accepted for any errors or omissions. We reserve the right to make technical changes. © Schaeffler Technologies AG & Co. KG Issued: 2015, October This publication or parts thereof may not be reproduced without our permission. © Schaeffler Technologies AG & Co. KG
© Copyright 2024 Paperzz