Product Bulletin
LINK QUALITY™
Product Information
Guaranteed Analysis
LINK QUALITY is a potassium phosphite base material that contains
a fully chelated iron and manganese micronutrient package.
Potassium phosphites have shown to promote plant vigor, increase
turgidity of the plant and rigidity of cell wall strength.
Total Nitrogen (N)........................................................................... 5.00%
0.50% Ammoniacal Nitrogen
4.50% Urea Nitrogen
Soluble Potash (K2O)...................................................................20.00%
Product Features and Benefits
•
Contains 20% phosphite (H3PO3) from potassium phosphite to
promote overall plant vigor
•
Potassium phosphite applications have been shown to increase
plant quality during stressful growing conditions
•
Fully chelated iron and manganese for maximum uptake,
availability and tank mix compatibility
•
Tank mix with LINK 17-0-3, 18-0-3 and 12-0-12 to enhance
effectiveness
•
Readily absorbed into the tissue and roots of plants
Iron (Fe)............................................................................................ 0.50%
0.50% Chelated Iron
Manganese (Mn)............................................................................ 0.50%
0.50% Chelated Manganese
Derived from: Potassium Carbonate, Urea, Ammonium
Hydroxide, Potassium Phosphite, Manganese EDTA, and Iron EDTA.
K2O Conversion Rate
Product Application
Turfgrass
Greens and Tees: Apply 1-6 ounces per 1,000 sq. ft. in a minimum of
2 gallons of water. Repeat as needed, allowing a minimum of 14 days
between treatments. Corresponding rates per acre are 1½-8 quarts in a
minimum of 80 gallons of water.
Fairways and Lawns: Apply 1-6 ounces per 1,000 sq. ft. in a minimum of
2 gallons of water. Repeat as needed, allowing a minimum of 14 days
between treatments. Corresponding rates per acre are 1½-8 quarts in a
minimum of 80 gallons of water.
ORNAMENTALS
Foliar Spray Rates:
Herbaceous Plants or Greenhouses: Do not exceed a maximum product
concentration of 0.10% v/v or apply more than 1 quart per acre per
application. Allow at least 1 week between applications. Note: 0.10% v/v
equals approximately 0.25 ounces per 2 gallons of water or 12 ounces
per 100 gallons of water.
Trees and Shrubs or Field-Grown Nursery: Do not exceed a maximum
product concentration of 0.30% v/v or apply more than 2 quarts per
acre per application. Allow at least 1 week between applications. Note:
0.30% v/v equals approximately 0.75 ounces per 2 gallons of water or 38
ounces per 100 gallons of water.
Use as part of a comprehensive Total Nutrition System® for
optimizing plant growth, development, yield and quality. For
more information contact your Wilbur-Ellis nutrition specialist.
ag.wilburellis.com
Pounds of K2O
per 1,000 sq. ft.
Amount of LINK Quality to
apply per 1,000 sq. ft.
0.10 pound
5.5 ounces
Soil Application Rates:
Transplanting and Establishment of Flowering, Bedding and
Herbaceous Plants: Momentarily submerge the entire seedling tray in a
0.10% v/v solution. Note: 0.10% v/v equals approximately 0.25 ounces of
LINK QUALITY per 2 gallons of water or 12 ounces per 100 gallons
of water.
Field-Grown Nursery: As an infrequent application, do not exceed a
maximum product concentration of 0.50% v/v. Note: 0.50% v/v equals
approximately 1.25 ounces of LINK QUALITY per 2 gallons of water or
64 ounces per 100 gallons of water.
Injection Rates: Apply at a rate of 50-150 ppm of K2O.
PPM OF K2O CONVERSION RATE: For 100 ppm of K2O, prepare a stock
solution by mixing 5 gallons of LINK QUALITY in 50 gallons of water and
inject stock solution at a ratio of 1:285.
Christmas Trees and Outdoor Plantings of Woody
Ornamentals:
New Plantings and Resets: Once the trees are set in the ground, apply
up to 2 gallons of a 0.50% v/v solution to the root zone of each tree and
1 quart for small shrubs. Make additional foliar applications of 1 quart
per acre at a 2-week spray interval during the growing season. Make
a minimum of 2 foliar applications per season. Note: 0.50% v/v equals
approximately 1.25 ounces of LINK QUALITY per 2 gallons of water or
64 ounces per 100 gallons of water.
Maintenance: Make foliar applications of 1 quart per acre at 2-week
spray intervals during the growing season. Make a minimum of 2 foliar
applications per season when plants are actively growing.
952.898.5562
For information only. Not a label. Prior to use, always read and follow the product label directions.
WILBUR-ELLIS Logo, Ideas to Grow With, LINK and Total Nutrition System are registered trademarks,
and LINK Quality is a trademark of Wilbur-Ellis Company. K-0113-030