HOW TO USE THE NEW HOBART LXi DISHWASHER
(DO NOT TURN THE CIRCUIT BREAKERS ON OR OFF!)
Dishwasher Display Panel
1. Turn the dishwasher on by pressing the “ON” button at least 10 minutes before
you want to begin to wash dishes. It takes approximately ten minutes for the sump
water to heat up. During this time the "fill" icon will flash.
2. When the "fill" icon stops flashing and the display shows only the water
temperature, you may begin washing dishes.
3. Prepare items to be loaded into the dishwasher – see pages 2 and 3.
4. Load the items onto the tray (as illustrated below) and slide into the dishwasher.
5. Add detergent; close door.
6. Press the “WASH” button.
7. Continue steps 3-6 until you are through washing all items.
1
C:\Users\Louis\Documents\DATA\LPC\Trustees\Trustee Handbook\Sec 6 - Maintenance\6-4 Kitchen\How to use the Hobart LXi dishwasher.doc
9/15/2004
8. When you are completely done washing dishes:
a. Close the door and turn the machine off by pressing the “OFF” button.
If you turn the dishwasher off between washes, you will have to wait for it
to heat the water again.
b. Remove the screen/filter at the bottom of the dishwasher, clean and put
back – see diagram below.
9. See “End of Day Procedure” on page 3 for complete shutdown instructions. Prop
the door open using the wooden spacer.
2
C:\Users\Louis\Documents\DATA\LPC\Trustees\Trustee Handbook\Sec 6 - Maintenance\6-4 Kitchen\How to use the Hobart LXi dishwasher.doc
9/15/2004
3
C:\Users\Louis\Documents\DATA\LPC\Trustees\Trustee Handbook\Sec 6 - Maintenance\6-4 Kitchen\How to use the Hobart LXi dishwasher.doc
9/15/2004