and
Tent Setup
1. Remove tent roll from compression sack. Untie bow. Set aside
rain fly, stakes, and poles.
2. Unroll tent. Lay out with mesh side up.
3. Remove poles and unwind.
4. Feed two poles across tent
through nylon covers (for Scorpion, through
plastic hooks).
5. Snap all fastening hooks to poles.
1
and
6. (Recluse) Feed third pole through hooks, crossing the other two
poles, either above or below other two.
7. One pole at a time, insert end pieces into receptacle
bezel, push pole further up and bend until
you can fasten the other end into its
receptacle. (Recluse) Crisscross the two
sleeved-poles at ends to ensure correct
placement.
On single cross-pole, make sure the center
hook is attached.
2
and
8. Install gear loft inside tent by attaching hooks to loops above on
four corners of tent ceiling.
9. Remove stakes from pouch, insert through loops on tent corners
and drive into ground at an angle.
Rain Fly
1.
Drape rain fly over tent with Ledge Logo and ropes facing
outward. On the four corners, fasten the rain fly buckles to
receptacles located on tent pole
fasteners. Tighten as necessary to
align rainfly seams with underlying
poles.
3
and
2. Extend vestibules, stake looped-corners to the ground.
Locate red guy lines on sides and stake to ground for added
stability.
Take Down Instructions
1. Remove all stakes and store in pouch.
2. Unclip rain fly and remove from tent. With outside of rain fly
facing up, fold outer corners inward and fold in half until it is a
manageable
size, as
shown.
4
and
3. Remove support poles from corner posts and release hooks
from poles.
4. Wind up and fold poles. Store in storage bag.
5. Spread out tent. Fold outside corners into center.
5
and
Fold in half again.
6