How to Make Standard Vauxhall AUX Input Work With
D5103/D5107/D5108Z
Special thanks to our loyal customer Rafe who shared this useful guide with us.
Method 1:
For guys who have Eonon D5103/D5107/D5108Z, you may find that your standard
Vauxhall aux input won't work with your unit. Here is an easy way to get it fixed.
1. Take the 'Special Port' of your D5103/D5107/D5108Z which looks like this:
2. Pull apart the two black clips at the bottom to remove a white block which will have
three wires running into it:
3. Remove the wires by pressing a small object (you can use a ball point pen) into the slot
on the side of the white block, pushing in the metal barb holding it in place and allowing
you to pull it out:
4. Then replace them in the correct configuration, as shown below:
(this is the top side)
Plug it back in and the AUX will work. :) It will only take you 3 minutes to do.
Method 2:
The aux inputs on the Eonon are 2x female RCA jacks, while the standard one is a few
wires that go into the back of the quadlock connector.
If you want to make the standard AUX input work, you can also use a conversion cable to
connect them. Lots of these cables are available on ebay. All you would need is something
like this:
you would have to replace the current female jack plug in the center console with this one
and wire it up tot he back of the HU. That will be OK.
Hope it helps! And have fun with your D5103/D5107/D5108Z!