Parts list for the KAPtery Pendulum Kit
Full Assembly and Use Guide at KAPtery.com/guides
For spare parts: KAPtery.com
Technical support: http://kaptery.com/contact/
The Pendulum is available in two versions: a mostly assembled pendulum, and a kit
which requires 45 -60 minutes for assembly using the parts in this list. There are no 3D
printed parts in this design.
Fiberglass shaft
The 38 cm hollow tube shaft

1 38 cm piece of carbon
fiber or fiberglass tube, 7.5
to 8 mm OD
Attachment hardware

1 20 cm long piece of high
pressure PVC tubing,
OD 17/32”

These parts will build a pendulum suspension.
1 4 cm long piece carbon or
fiberglass tube

2 steel hairpin cotter pins, 1 3/8”

1 steel hairpin cotter pin, 1 5/8”

1 vinyl coated 2 mm steel wire, ~25 cm long

2 white vinyl cap
Lanyard


1 small carabiner
1 meter piece of 50 pound test braided Dacron line