Wheel Simulator Mounting Instructions
Pacific Dualies, Inc. Installation Manual & Limited Warranty
Snap-On (Style 2)
Over-The-Lug Mounting Style (Style 3)
Mounting style designed with strong steel gripping teeth reinforced by
springs that grasp firmly onto the wheel of the vehicle holding the
simulator securely in place. Removal of (OEM) lug-nuts are not required.
Mounting style designed with built-in jam nuts that screw over the
original equipment (OEM) studs on the wheel. Removal of (OEM) lug-nuts
are not required.
Item 2.
Item 2.
Item 3.
Item 4.
OEM Wheel
OEM Wheel
Wheel Simulator Kit Contains:
Item 1. (2) Stainless Steel Front
Wheel Simulators
Item 2. (2) Stainless Steel Rear
Wheel Simulators
Item 1. (2) Front Wheel Covers
Item 2. (2) Rear Wheel Covers
Item 3. Lug-nut covers w/Jam-nuts.
(Qty. depending on application)
Item 4. (4) Pop-out center plates
(For Front Wheel Hub Access)
Item 5. (1) Lug-nut/Jam-nut Removal Tool
! WARNING
*Failure to follow all instructions could result in wheel loss, resulting in serious injury or death
**Read all instructions before beginning installation & Follow all instructions in order presented
! WARNING
*Failure to follow all instructions could result in wheel loss, resulting in serious injury or death
**Read all instructions before beginning installation & Follow all instructions in order presented
Wheel Simulator Kit Contains:
Installation:
Step 1. Align either a front or rear simulator to the corresponding
(OEM) wheel.
Step 2. With a quick firm nudge, press the simulator into the (OEM)
wheel - making sure that the wheel simulator snaps securely
into place.
Step 3. Repeat Steps 1& 2 on each of the remaining (OEM) wheel
Installation:
Step 1. Begin by sliding on a front or rear wheel simulator cover onto the
vehicle wheel without removing any of the OEM lug-nuts - allowing
four of the OEM lug-nuts and studs to clear the four enlarged holes
on the wheel simulator cover.
Step 2. Carefully bolt on the Pacific Dualies lug-nut covers - securing them to
the remaining threading left on the OEM studs.
Warning - *Hand Tighten using tool provided*
Warning - **Do Not Use Impact Wrench**
Step 3. Snap on the Pop-Out Center Plates on to the center of the
corresponding wheel simulator cover.
3 Snap - On Mounting Style
Over - The - Lug Nut Mounting Style 4