CAR ALARM META SERVICE TYPE OF CAR AND YEAR OF MANUFACTURE MERCEDES CLASS A SHEET NO. 25.27 INSTALLATION POSITION Compact central units and sirens: install in the engine compartment inside the driver side wheel housing. Central control units and accessories: behind the centre console or in the battery compartment. POWER SUPPLY Positive: connect to a shunt in the fuse box. Negative: directly to the connection pre-engineered by car maker. ENGINE IMMOBILISATION Fuel pump: cut the blue/red wire (0.5 mm2) connected to the relay marked K7 in the fuse box. Starter motor: cut the pink/purple wire (2.5 mm2) connected to fuse 8 (30A) in the fuse box. NB: Use an additional relay. KEY POSITIVE (+15) Connect to the pink/red wire (2.5 mm2) connected to the relay marked K8 in the fuse box CENTRAL LOCKING Negative electric controls. Connect to the green/blue wire without cutting it for the anti-theft system opening and closing commands. Find this wire behind the door opening and closing button in the centre console. TURNING INDICATORS All the car blinkers are commanded separately. Therefore use 6 diodes rated at least 10A and connect to the black/white (0.75 mm2) and the black/yellow (0.75 mm2), black/green (0.75 mm2), black/purple (0.75 mm2) wires in the right connector at the rear of the instrument panel and also to the black/white/blue (0.5 mm2) and black/green (0.5 mm2) wires in the left connector at the rear of the instrument panel. DOOR AND BOOT PROTECTION Connect to the brown/red (0.5 mm2) or brown/white (0.5 mm2) wire in the left connector at the rear of the instrument panel. BONNET PROTECTION Use the button in the kit. PASSIVE ALARM ACTUATION Comply with the connection instructions illustrated in ENCLOSURE 25.27.1 (M750/...) NOTE: For cars equipped with a catalytic converter, refer to the section entitled CATALYST or cut power to fuel pump. ☞ THE INFORMATION GIVEN IN THE MANUAL IS PURELY INDICATIVE AND SHOULD BE VERIFIED BEFORE MAKING ANY CONNECTIONS AS THE CAR MANUFACTURERS MAY MAKE MODIFICATIONS WITHOUT PRIOR NOTICE. META SYSTEM DECLINES ANY LIABILITY FOR DAMAGE TO THE VEHICLE CAUSED BY INCORRECT INSTALLATION. CAR ALARM META SERVICE TYPE OF CAR AND YEAR OF MANUFACTURE ENCLOSURE MERCEDES CLASSE A 25.27.1 Installation annex M750/1 with electronic key SET UP: TURNING INDICATOR LEARNING MODE Function Vehicle Wire Colour M750 Wire Colour Location in vehicle Arming command Red/Black Green/Yellow 8-pin black connector of original Blinker button in centre of dashboard Inhib./Arm. command Red/Yellow Green/White 8-pin black connector of original Blinker button in centre of dashboard. Light blue Black/White Black/Green Black/White/Blue The 6 wires are at the rear of instrument panel divided between rh connector (4 wires) and lh connector (2 wires) Light blue Black/Yellow Black/Purple Black/Green WARNING: use diode module in kit (consult wiring diagram fig.). Turning indicator Turning indicator CONNECTION TO DIODE MODULE P69797 (to purchase separately) Diodi 1N5402 (3A) LIGHT BLUE LIGHT BLUE LIGHT BLUE LIGHT BLUE M750/1 LH Front turning indicator (BLACK/WHITE vehicle wire) (LIGHT BLUE/WHITE diode module wire) LH Side turning indicator (BLACK/GREEN vehicle wire) (LIGHT BLUE/BLACK diode module wire) LH Rear turning indicator (BLACK/WHITE/BLUE vehicle wire) (LIGHT BLUE/YELLOW diode module wire) RH Front turning indicator (BLACK/YELLOW vehicle wire) (RED/WHITE diode module wire) RH Side turning indicator (BLACK/PURPLE vehicle wire) (RED/BLACK diode module wire) RH Rear turning indicator (BLACK/GREEN vehicle wire) (RED/YELLOW diode module wire) RH Front turning indicator (BLACK/WHITE vehicle wire) Instrument Panel RH connector (viewed from driver's side) LH Side turning indicator (BLACK/GREEN vehicle wire) LH Rear turning indicator (BLACK/WHITE/BLUE vehicle wire) RH Front turning indicator (BLACK/YELLOW vehicle wire) RH Side turning indicator (BLACK/PURPLE vehicle wire) 7 RH Rear turning indicator (BLACK/GREEN vehicle wire) Instrument Panel LH connector (viewed from driver's side) NOTE: For cars equipped with a catalytic converter, refer to the section entitled CATALYST or cut power to fuel pump. ☞ THE INFORMATION GIVEN IN THE MANUAL IS PURELY INDICATIVE AND SHOULD BE VERIFIED BEFORE MAKING ANY CONNECTIONS AS THE CAR MANUFACTURERS MAY MAKE MODIFICATIONS WITHOUT PRIOR NOTICE. META SYSTEM DECLINES ANY LIABILITY FOR DAMAGE TO THE VEHICLE CAUSED BY INCORRECT INSTALLATION.
© Copyright 2024 Paperzz