FM AMPLIFIER MEDIUM POWER | E5000D-IN
FM AMPLIFIER MEDIUM POWER
| E5000
Datasheet
COMPOSITION
Exciter (Indium series)
Exciter Indium Series single drive
Amplifier
Amplifier E5000 Indium Series HOT PLUGGABLE
GENERAL DATA
Output Nominal Power
5000 W adjustable
Operating band
87.5 ÷ 108 MHz
RS232/RS485
Yes. Connector DB9 female
Points of measure
RF Sample - MPX Monitor
Displayed Parameters
More than 50 parameters displayed on a wide
graphic 0-LED screen
From the frontal panel through OLED/from PC
Adjustments
Number of L-DMOS in amplifier stage
RF power stage technology
7
ICEFET & ECOSAVING
Dimensions: Rack units
4U
Dimensions: W - H - D
48.5 - 17.6 - 70 cm
Weight
35 Kg
Number of power supplies
3
Number of cooling fans
6
CONNECTORS
RF Output connector
RF Input connector
7/8" / 1+5/8" EIA (Optional)
N
RF PERFORMANCE
Output impedance
50 Ω
Automatic power RF control
Stabilizes the output power value on the
set value
+/- 0,1 dB
Overall output power RF stability
VSWR
Harmonics
2:1 at full power. Automatic power
reduction beyond 1.7:1. Transmitter is
protected fro open and short circuit.
< -75 dBc
Out of band emission (spurious)
< -80 dBc
AUDIO AND EXCITER PERFORMANCE
Driving power
INSTALLATION REQUIREMENTS
Power supply
Power consumption (typical)
2W *
230/400 Threephase-Singlephase
Version 50-60 Hz VAC
7.1 KW
* Elenos suggests to drive this amplifier with ETG20 Elenos Indium Series
FM AMPLIFIER MEDIUM POWER | E5000D-IN
Overall efficiency (typical from -3dB to Pnom)
Power factor
Current Consumption @ 230VAC/single phase
Magneto-thermic capacity @ 230VAC/single phase
Conductor size @ 230VAC/single phase
Conductor size @ 230VAC/single phase
Current Consumption @ 230VAC/three phase
Magneto-thermic capacity @ 230VAC/three phase
Conductor size @ 230VAC/three phase
Conductor size @ 230VAC/three phase
Current Consumption @ 400VAC/three phase
Magneto-thermic capacity @ 400VAC/three phase
Conductor size @ 400VAC/three phase
Conductor size @ 400VAC/three phase
COOLING/NOISE/DATA
Cooling system
Air temperature increase
Acoustic noise
> = 70%
> 0.95
31 Amp
45 Amp
10 sqrt.mm
7 AWG
18.5 Amp
32 Amp
6 sqrt.mm
9 AWG
10.5 Amp
20 Amp
4 sqrt.mm
11 AWG
Forced air-cooling . From 600 to 1200 m3/h
17 °C
< 65 phon
@ transmitter room, 2 m distance of the
front of transmitter
ENVIRONMENT
Temperature range (operating)
Temperature range (non operating)
Humidity range (operating)
Humidity range (non operating)
Altitude range (operating)
Altitude range (non operating)
-5 ÷ +45 °C, 23 ÷ 113 °F
-20 ÷ +55 °C, -4 ÷ 131 °F
95% @ 40 °C, 104 °F
90% @ 55 °C, 131 °F
<3000 meters / <9840 Feet
<15000 meters / < 49200 Feet
TELECONTROL & TELEMETRY
Remote control
Remote control, dry contacts
SNMP option
Yes
Yes
Yes (external)
Elenos suggests to drive this amplifier with ETG20 Elenos Indium Series
ETG DIGITAL TRANSMITTERS SERIES | ETG20 - IN
ETG DIGITAL TRANSMITTERS SERIES | ETG20 - IN
Datasheet
38 kHz Suppresion
> 70 dB
20 W adjustable
Pre-emphasis
0/25/50/75 microseconds selectable
Operating band
87.5 ÷ 108 MHz
Pre-emphasis tolerance
+/- 0.1 dB
Direct to channel
Yes
FM S/N (Mpx operation)
RS232/RS485
Yes. Connector DB9 Female
85 dB
20 Hz to 23 KHz @ 53 KHz - detector RMS
> 80 dB weighted
> 80 dB unweighted
@ 400 Hz, 75 KHz frequency deviation,
quasi-peak detector, 50 us de-emphasis
> 60 dB
@ 400 Hz, 75 us de-emphasis
GENERAL DATA
FM TRANSMITTER
| ETG20-IN
Output Nominal Power
Points of measure
RF Sample - MPX Monitor
FM S/N CCIR (Stereo/Mono operation)
Displayed Parameters
Adjustments
More than 50 parameters displayed on a wide
graphic OLED
From the frontal panel through OLED/from PC
Asynchronous AM S/N unweighted
Number of L-DMOS in amplifier stage
1 Drive Board
RF power stage technology
ICEFET & ECOSAVING
Dimensions: Rack units
2U
Dimensions: W - H - D
48.5 - 8.5 - 58.5 cm / 19.11 - 3.35 - 23.05 inches
Weight
9.4 Kg / 20.72 lbs
Number of cooling fans
2
Synchronous AM S/N
Amplitude Response
(Mpx/SCA/ RDS operation)
Amplitude Response
(Stereo/Mono operation)
CONNECTORS
RF Output connector
N
MPX Connector
LEFT & RIGHT Connectors (or Mono)
AES/EBU Connector
AUX Connectors
BNC
XLR
XLR
BNC
RDS
SCA
ETHERNET
19 kHz monitor
MPX monitor
10 MHz IN/OUT
PPS IN/OUT
GPS ANTENNA
BNC Female
BNC Female, 10 k Ohm - 600 Ohm
Stereo separation
Female balanced, unbalanced
Female
Female/optical
Female
RJ45
BNC Female
BNC Female
SMA60%
SMA60%
SMA
RF PERFORMANCE
Output impedance
50 1
Automatic power RF control
Stabilizes the output power value on the set value
Overall output power RF stability
+/- 0,1 dB
VSWR
Harmonics
2:1 at full power.
Automatic power reduction beyond 1.7:1.
Transmitter is protected from both open and short
circuit conditions.
< -85 dBc
Out of band emission (spurious)
< -85 dBc
AUDIO PERFORMANCE
MPX input level
+15/-10 dBu for 75 KHz standard deviation
MPX input impedance
Selectable 5 K unbalanced, 6001 balanced
L/R input level
+15/-10 dBu for 75 KHz standard deviation
L/R input impedance
Selectable 10 K - 600 , balanced
Electric and optical input
24 bits
32,44.1,48,96,192 KHz automatically selected
-20 dBFS - 0 dBFS
110 balanced
0 dBu @ 57 kHz- 99kHz
Soft adjust 0.05% steps from front panel
Soft adjust 0.01 degree steps from front panel
19 KHz
Soft adjust +/- 7.5 KHz
+/- 0.1 Hz
< 0.01% or better with 75 KHz frequency deviation < 0.01% or
better with 100 KHz frequency deviation 30 Hz to 15 KHz
< 0.03% or better with 75 KHz frequency deviation < 0.03% or
better with 100 KHz frequency deviation 30 Hz to 15 kHz
AES/EBU
AES/EBU input resolution
AES/EBU input sample rate
AES/EBU input level
AES/EBU input impedance
SCA/RDS input level
Pilot amplitude adjustment
Pilot phase adjustment
Pilot tone frequency
Pilot tone deviation
Pilot tone frequency stability
THD+N (Mpx operation)
THD+N (Stereo/Mono operation)
Linear crosstalk
Intermodulation distortion
Class of emission
Stereo emission
EXCITER PERFORMANCE
Frequency deviation
Maximum frequency deviation
Frequency stability
RF frequency steps
Phase Response
Internal sample rate
Oven 10 MHz
GPS
SFN
INSTALLATION REQUIREMENTS
Power supply
Power consumption (typical)
Current drain (typical @230V)
COOLING/NOISE/DATA
Cooling system
Acoustic noise
Air outlet
> 50 dB
@ 400 Hz, 75 us de-emphasis
+/- 0.1 dB (without pre-emphasis)
5 Hz to 100 kHz @ 400 Hz
+/- 0.1 dB (without pre-emphasis)
+/- 0.2 dB (with pre-emphasis)
20 Hz to 15 kHz @ 400 Hz
> 70 dB
20 Hz to 15 KHz
> 70 dB
20 Hz to 15 kHz
<0.05% Measured with two of tones
1 kHz & 1.3 KHz, ratio
1:1 at 100% modulation
F3
According to ITU-R reccomendation
450 (pilot tone)
+/- 75 KHz 0.1 dB steps adjustable
+/- 150 KHz
+/- 0.1ppm with oven
1 Hz
+/- 0.1 degree from linear phase
20 Hz to 100 KHz
2.4 GHz
Yes internal, aging +/- 0.1ppm year
Yes internal
Yes, with delay from 0 to 1s, step 100ns
110, 230 Two-Singlephase Version 50-60 Hz VAC
< 70 W
0,3 A
Forced air-cooling
< 65 phon
@ transmitter room, 2 m distance
of the front of transmitter
240 m3/h
ENVIRONMENT
Temperature range (operating)
Temperature range (non operating)
Humidity range (operating)
Humidity range (non operating)
Altitude range (operating)
Altitude range (non operating)
-5 ÷ +45 °C, 23 ÷ 113 °F
-20 ÷ +55 °C, -4 ÷ 131 °F
95% @ 40 °C, 104 °F
90% @ 55 °C, 131 °F
<3000 meters / <9840 Feet
<15000 meters / < 49200 Feet
TELECONTROL & TELEMETRY
Remote control
Remote control, dry contacts
SNMP option
Yes
Yes
Yes (external)
powered by 22hbg.com | FM AMPLIFIER MEDIUM POWER REV.2.0
Elenos S.r.l.
[email protected] / www.elenos.com
Elenos
Elenos USA
Elenos APAC
Via G. Amendola 9 / 44028 Poggio Renatico Ferrara (Italy) / Ph +39 0532 829965
1315 NW 98th Ct. Suite 9 / 33172, Miami (Florida) / Ph 1-855-ELENOS-0 (1-855-353-6670)
53/64 Saracha Villa, Sansuk / Muang Chonburi, Thailand / Ph +66 83 618-9333