Dalton Enterprise, Inc.
Product: Plushpatch™ Binder Kit 2000-01
Phone: (203) 272-3221
MSDS Date: 6/04/2010
Dalton Enterprises, Inc.
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________________________
Section I –CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name:
Plushpatch™ Binder Kit 2000-01
Product Description:
Exterior Latex Flat Paint
Supplier's Name
Emergency Telephone Numbers:
Dalton Enterprises.
DALTON ENTERPRISE: 1-203-272-3221
131 Willow St.
Information Telephone Number: (203) 272-3221
Cheshire, CT 06410
____________________________________________________________________________________________________________
Section II -COMPOSITION/INFORMATION ON INGREDIENTS
Dalton Plushpatch™ Binder Kit 2000-01:
CAS REG NO.
AMT.(%)
Synthetic Resin
25586-20-3
40.0 - 50.0
Crystalline Silica
14808-60-7
30.0 – 50.0
See Section VIII, Exposure Controls/Personal Protection
NOTE: Per 29CFR 1910.1200 (g) (2) (1) (c) (2), only hazardous substances present in excess of 1.0%/wt (or 0.1% for carcinogens) must be listed on
an MSDS. Ingredients total %/Wt are below 100% only if all others unlisted are not considered hazardous by any federal (OSHA, WHMIS,
SARA), any state or province, or local Right-To-Know regulations.
____________________________________________________________________________________________________________
Section III – HEALTH HAZARDS
Primary Routes of Exposure
Inhalation
Eye Contact
Skin Contact
Inhalation:
Inhalation of vapor or mist can cause the following:
Excessive inhalation of vapors can cause nasal and respiratory irritation, dizziness, weakness, fatigue, nausea
and/or headache. Overexposure can cause neurological damage. Mists or vapors from hot operations can
cause mental sluggishness, pulmonary edema (accumulation of fluid in the lungs, signs and symptoms can be
delayed for several hours) and bronchial pneumonia.
Eye Contact:
Direct contact with material can cause the following:
Trace amounts of amine and residual monomer vapors may be irritating to the eyes, especially in poorly
Page 1 of 5
Dalton Enterprise, Inc.
Product: Plushpatch™ Binder Kit 2000-01
Phone: (203) 272-3221
MSDS Date: 6/04/2010
ventilated areas. Irritation in the form of redness, tearing and/or blurred vision.
Skin Contact:
Prolonged or repeated skin contact can cause the following:
Due to individual sensitization, this product can cause skin irritation upon prolonged or repeated contact.
Ingestion:
Can cause gastrointestinal irritation, nausea, vomiting and diarrhea.
____________________________________________________________________________________________________________
Section IV –FIRST AID MEASURES
Inhalation:
If overcome by mist or vapor, remove from exposure immediately. If breathing is stopped or irregular, Seek
immediate medical attention.
Eye Contact:
Flush eyes with a large amount of water for at least 15 minutes, lifting upper and lower eyelids occasionally. Consult a
physician if irritation persists.
Skin Contact:
Remove contaminated clothing. Wash affected skin areas thoroughly with soap and water. Consult a physician if
irritation persists.
Ingestion:
DO NOT INDUCE VOMITING. Drink 2 glasses of water to dilute. Consult a physician or poison control center
immediately. Treat symptomatically.
___________________________________________________________________________________________________________
Section V – FIRE FIGHTING MEASURES
Flash Point
212°F/100°C
Auto-ignition Temp
Not Established
Lower Explosive Limit
Not Applicable
Upper Explosive Limit
Not Applicable
Special Firefighting Procedures:
Wear self-contained breathing apparatus and full protective gear.
Extinguishing Agents:
Water Spray: OK
Carbon Dioxide: OK
Foam: OK
Dry Chemical: OK
Halon: OK
Other: Any “ABC” class
____________________________________________________________________________________________________________
Section VI – ACCIDENTAL RELEASE MEASURES
Steps to be Taken in Case Material is Released or Spilled:
Page 2 of 5
Product: Plushpatch™ Binder Kit 2000-01
Dalton Enterprise, Inc.
Phone: (203) 272-3221
MSDS Date: 6/04/2010
Minimize contact with the skin, eyes, and do not take internally. Ventilate confined spaces. Keep unnecessary people
away. Dike and contain spill with inert material (e.g. sand, earth). Transfer liquids and contaminated diking material
to separate, and suitable, containers for recovery or disposal.
Caution:
Keep spills and cleaning runoff out of municipal sewers and open bodies of water.
Waste Disposal Method:
Dispose of in accordance with local, state and federal regulations.
____________________________________________________________________________________________________________
Section VII – HANDLING AND STORAGE INFORMATION
Storage Conditions:
Keep closures tight, and containers upright to prevent leakage. Keep from freezing.
Handling:
When handling, do not eat, drink, or smoke. Thoroughly wash hands before eating or smoking.
___________________________________________________________________________________________________________
Section VIII – PERSONAL PROTECTION/EXPOSURE CONTROL
Engineering Controls (Ventilation):
In confined areas, use local exhaust ventilation (hoods).
Respiratory Protection:
Not required under normal conditions in a well-ventilated workplace. An organic vapor respirator National Institute
for Occupational Safety and Health (NIOSH) approved for organic vapors is recommended under emergency
conditions.
Eye Protection:
Chemical safety glasses, goggles and/or face shields.
Hand Protection:
Chemical resistant gloves.
Other Protective Equipment:
Facilities storing or utilizing this material should be equipped with an emergency shower and eyewash station.
___________________________________________________________________________________________________________
Section IX – STABILITY AND REACTIVITY DATA
Chemical Stability:
Stable at ambient temperatures.
Incompatibility: (Conditions/Materials to avoid)
Strong oxidizers, strong acids or bases, and selected amines.
Hazardous Polymerization:
Will not occur.
Page 3 of 5
Dalton Enterprise, Inc.
Product: Plushpatch™ Binder Kit 2000-01
Phone: (203) 272-3221
MSDS Date: 6/04/2010
Hazardous Decomposition Products:
Thermal decomposition in the presence of air may yield carbon monoxide and/or carbon dioxide.
___________________________________________________________________________________________________________
Section X – PHYSICAL DATA
Appearance
Color
State
Odor
Boiling Point
Molecular Weight
Specific Gravity (Water=1)
Vapor Density (Air=1)
Solubility in Water
Percent Volatility
pH
Viscosity
Max VOC:
Thin liquid
Grey
Liquid
Mild odor
N/A
Mixture
1.1
N/A
Completely (100%)
56.45
7.5-9.5
100-1,000 cps
Less than 5 g/l.
Section XII – TOXICOLOGICAL INFORMATION
U.S. TOXIC SUBSTANCES CONTROL ACT (TSCA): All components of this product are in compliance with the inventory
listing requirements of the U.S. Toxic Substances Control Act (TSCA) Chemical Substance Inventory.
Section XII – ECOLOGICAL INFORMATION
There are no known adverse ecological effects of this product.
Section XIII – DISPOSAL CONSIDERATIONS
Dispose in accordance with federal, state and local regulations.
Section XIV – TRANSPORT INFORMATION
PROPER SHIPPING NAME: WATER BASED MATERIAL
HAZARD CLASS: NOT REGULATED
SUBSIDIARY HAZARD CLASS: NONE
DOT IDENTIFICATION NUMBER: NONE
DOT SHIPPING LABEL: NONE
Section XV – REGULATORY INFORMATION
This product contains no chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and
Community-Right-To-Know Act of 1986 and of 40 CFR 372.
Section XVI – OTHER INFORMATION
Hazard Rating Systems
Page 4 of 5
Product: Plushpatch™ Binder Kit 2000-01
Dalton Enterprise, Inc.
Phone: (203) 272-3221
NFPA 704*
Health:
Flammability
Reactivity
0
0
0
HMIS**
Health:
1
Flammability 0
Reactivity
0
Personal Protection
MSDS Date: 6/04/2010
Key:
0 - Insignificant;
1=Slight
2 = Moderate;
3=High
4= Extreme;
B= Eye Protection and gloves
B
*National Fire Protection Association rating identifies the severity of
hazards of material during a fire emergency (i.e., “on fire”)
**Hazardous Materials Identification System, National Paint and Coatings
Association rating applies to product “as packaged” (i.e., ambient temperature)
____________________________________________________________________________________________________________
NOTICE
This information is furnished without warranty, representation, inducement or license of any kind, except that it is accurate to
the best of Dalton's knowledge or obtained from sources believed by Dalton to be accurate. Dalton does not assume any legal
responsibility for use or reliance upon same information. Customers are encouraged to conduct their own tests. For
additional technical information contact Dalton Enterprises.
Page 5 of 5