operating and installation instructions

Sales:
LAVACUR ® Germany
WORLDTRADER Holding GmbH
Hauptstrasse 1A
86682 Genderkingen
Germany
Tel. +49 (0) 90 90-95 95 77
Fax +49 (0) 90 90-95 95 76
I N FO @ LAVACU R.DE
WWW.LAVACU R.DE
Instructions for using hotel hair dryer
With anti-theft wall bracket
Art. no.: 8008
Settings:
The required power settings can be selected with the
switch on the handle:
1 > 600 watt setting for styling hair
2 > 1200 watt setting for drying hair
Press and hold the button
> to select the required power setting
Explanation to Fig. 2
1.
2.
3.
4.
Hair dryer
Hair dryer holder
Slide switch power settings 1 – 2 (MIN/Max)
Safety PUSH button
Only operates when BUTTON is depressed
5. Rear plate
6. Additional isolating switch on wall bracket
7. Cable with plug
Technical data:
2
5
3
4
6
1
Technical data:
• 220 – 230 V
• 50 Hz
• 1200 W
7
Fig. 2
Sales:
LAVACUR ® Germany
WORLDTRADER Holding GmbH
Hauptstrasse 1A
86682 Genderkingen
Germany
Tel. +49 (0) 90 90-95 95 77
Fax +49 (0) 90 90-95 95 76
I N FO @ LAVACU R.DE
WWW.LAVACU R.DE
Mounting instructions for hotel hair dryer
With anti-theft wall bracket
Art. no.: 8008
Connection to supply/Mounting:
A.) Connection to supply with plug: (Fig. 1)
1. Drill two 6 mm diameter holes in the wall (Fig. 1).
Insert a dowel into each hole.
Fix the mount 1 in place with a screw.
2. Position the rear plate precisely on the mount and
fix the hair dryer holder and rear plate in place with a
screw.
3. Plug into the socket-outlet.
70 mm
1
Bild 1
4
2
3
5
Bild 2
B.) Direct connection to supply: (Fig. 3)
1. Drill two 6 mm diameter holes in the wall (Fig. 1).
Insert a dowel into each hole.
Fix the mount 1 in place with a screw.
2. Loosen the screw 2 in the hair dryer holder and
remove. Remove the power cable with plug from the
cable terminal. 3
3. Break out the circular plastic cut-out 4 at the rear.
Feed the cable through this cut-out. Place the rear
plate precisely on the mount and fix in place with a
screw.
4. Connect the prepared power cable to the cable terminals N and L.
5. Check and subsequently mount the hair dryer holder using the circular cover for
closing the cable outlet 5 and tighten with the previously loosened screw.