WDS105+ Datasheet - Sonic Concepts, Inc.

ULTRASONICS FOR THE PHYSICAL WORLD
WDS-105+
Water Degassing System Model WDS-105+
The water degassing system Model WDS-105+ uses a hydrophobic membrane cartridge
and a vacuum to remove dissolved gases from the water. Water is circulated through the
degassing cartridge and heater unit using an impeller-type pump. As the water passes
through the cartridge, it is exposed to a vacuum through the pores. The total surface area
of the pores is quite large (approaching 0.10 m2), and the dissolved gas content in the water
quickly equilibrates with this vacuum level. Externally mounted fill and drain valves control
the amount of water in circulation allowing an inflatable membrane to be adjusted. Since
the water does not pass directly through a vacuum (as in other degas methods), the total
energy requirement is quite low. A compact vacuum pump is used to generate a vacuum
level of 100 millibars. All pump parts are compatible with water vapor.
The heater runs on low voltage DC power and is controlled by an internally mounted PID
Temperature Controller. The heating element is enclosed in stainless steel piping and is
protected with a high-temperature cutoff switch to ensure it cannot damage to the system.
The controller is user adjustable and can be easily programmed to maintain temperature
at a wide range of set points. The controller is also able to learn your setup to minimize
overshooting while maintaining your desired temperature.
The water circulation pump is a magnetically-coupled gear driven type. The system includes
a timer so that the degas process can cycle and shut off unattended. The water circulation
pump has a speed control knob mounted inside the system to adjust water flow rate as
required. All components are mounted in a single enclosure.
Specifications
Degas time: 60 minutes to <18% of saturation, starting at 100% saturation, at room temperature, for volumes up to 10 liters
Water temperature: 5 – 30o C operating range, externally heated or cooled prior to filling
Temperature display:
When heating unit is turned on (C or F)
Heating unit: 100W – Able to raise 10L 10oC above ambient in less than 1 hour
Temperature controller: Learning PID Control with Dual Temperature Display
Vacuum pump:
100 millibars (27 inches Hg), 2 liters/minute, continuous
Water pump:
500 – 2000 mL/min, continuous duty, 3.45 bar (max), (50 PSIG)
Timer:
Mechanical 0 – 6 hour timer, controls vacuum and circulation pump
Construction:
Desktop cabinet with clear door, plastic water housing, Tygon tubing (wall-mount kit included)
Size:
60cm H x 40cm W x 25cm D (24”H x 16”W x 10”D)
Power input:
100-240 VAC, 50-60Hz, up to18A (12 VDC internal to cabinet)
Sonic Concepts, Inc.
18804 North Creek Parkway / Suite 103 / Bothell, WA / 98011 / USA
Tel : +1 (425) 485 2564 Fax : +1 (425) 485 7446
Sales and quote requests : [email protected]
Technical support, general information : [email protected]
WDS-105+
ULTRASONICS FOR THE PHYSICAL WORLD
Figure 1.
Diagram of the WDS-105+ degassing
system.
100-240 VAC,
50-60Hz
Power
On / Off
With Timer
Vacuum
Pump
Water
Vapor
PID
Temperature
Controller
Speed
Control
Flask
Water
Heater
Degas
Cartridge
Circulation
Pump
Reservoir
Fill and
Drain
Valves
Figure 2.
System Test Results
Sonic Concepts, Inc.
18804 North Creek Parkway / Suite 103 / Bothell, WA / 98011 / USA
Tel : +1 (425) 485 2564 Fax : +1 (425) 485 7446
Sales and quote requests : [email protected]
Technical support, general information : [email protected]
Water Lines
Shown in Bold
HIFU
Transducer
( with Inflatable
Membrane)
Located Outside
of Cabinet