c4 infrared co2 ch4 c3h8 gas sensor - Euro-Gas

INFRARED SENSOR FOR
CO2 OR HYDROCARBONS
1. FEATURES
•
•
•
•
•
•
•
•
Standard 20 or 32 mm sensor size
Fast response
Internal temperature signal
Robust construction
Temperature compensated detector elements
Wide operating temperature and humidity range
Low power consumption
ATEx approved version available in 4 series size
2. DESIGN
Infrared CO2, CH4 or C3H8 sensor
in 4 or 7 series standard sizes
with 7 pins
The C/M/P4 series of infrared gas detection sensors
utilise NDIR (Non Dispersive Infrared) to monitor the
presence of hydrocarbons or Carbon Dioxide.
Part nos.: 2112BC/M/P4 (4 or 7
series sizes) or 2112BC/M/P4A for
ATEx version (4 series size only)
The sensor consists of an infrared light source, an optical
cavity, a dual output pyroelectric detector, a thermistor to
monitor the temperature and the electronics. The gas
diffuses into the optical cavity through a special filter
membrane (optional) designed to enhance the ingress
protection (IP) of the sealed enclosure.
Measuring ranges:
Carbon Dioxide CO2:
0-100% vol, 0-30% vol,
0-5000ppm, 0-2% vol, 0-5% vol
Methane CH4 & Propane C3H8:
0-100% LEL or 0-100% vol
Inside the cavity, the lamp emits an infrared pulsing radiation that gets partially absorbed by
the present gas. The pyroelectric detector is sensitive to thermal energy changes and returns
two outputs in response to the pulsed light from the infrared light source:
• an active sinusoidal signal output that decreases in amplitude when the target gas is
present in the cavity.
• a reference sinusoidal signal output that measures the light intensity of the infrared source
(this signal remains unaffected by the presence of target gas)
An infrared gas sensor naturally senses temperature by absorbing radiation but it also
responds to temperature changes in the environment, which can give rise to spurious and
misleading signals. For this reason, an NTC thermistor measures the internal temperature of
the sensor.
The sensor requires suitable electronic and software interfaces in order to produce an output
that is linearised and temperature compensated.
EURO-GAS MANAGEMENT SERVICES LTD, CHURSTON HOUSE,
BASCOMBE ROAD, CHURSTON FERRERS, DEVON, TQ5 0JJ, UK
«: +44 (0)1803 844414 Fax: +44 (0)1803 844224
[email protected]
www.euro-gasman.com
INFRARED SENSOR FOR
CO2 OR HYDROCARBONS
3. TECHNICAL DATA
INFRARED SENSOR FOR
CO2 OR HYDROCARBONS
4. PERFORMANCE
Typical absorbance data for 20mm version sensor
Typical absorbance data for 32mm version sensor
The data contained in this document is believed to be accurate and reliable. The data given is for guidance only.
Euro-Gas Management Services Ltd accepts no liability for any consequential losses, injury or damage resulting from
the use of this datasheet or the information contained in it. Customers should test the sensors under their own
conditions to ensure that the sensors are suitable for their own requirements and in accordance with the plans and
circumstances of the specific project and any standards/regulations pertaining to the country in which the sensors will
be utilised. This datasheet is not intended to form the basis of a contract and in the interest of product improvement,
Euro-Gas reserves the right to alter design features and specifications without notice.
02/13
EURO-GAS MANAGEMENT SERVICES LTD, CHURSTON HOUSE,
BASCOMBE ROAD, CHURSTON FERRERS, DEVON, TQ5 0JJ, UK
«: +44 (0)1803 844414 Fax: +44 (0)1803 844224
[email protected]
www.euro-gasman.com
INFRARED SENSOR FOR
CO2 OR HYDROCARBONS
4. DIMENSIONS
32mm size
20mm size
5. ORDERING DETAILS
When ordering, please specify the basic physical properties that are needed for the specific
application. This is made through the part number selection below. The squared fields of the
part number below can be modified according to the options on the right.
Main gas sensor product codes: CO2 = 2112BC4, CH4 = 2112BM4, C3H8 = 2112BP4
With following options available:
EURO-GAS MANAGEMENT SERVICES LTD, CHURSTON HOUSE,
BASCOMBE ROAD, CHURSTON FERRERS, DEVON, TQ5 0JJ, UK
«: +44 (0)1803 844414 Fax: +44 (0)1803 844224
[email protected]
www.euro-gasman.com