Product Knowledge Training
Video Quiz 1 Master
“How to Load a Bulk Caulk Gun from a Pail”
(http://albioneng.com/product-resources-videos)
1
Answer Key
1.) Match the product description with the Albion part number: (6 pts.)
1
2
3
4
5
6
Barrel
Barrel brush
Conical ejector
Lock ring
Leather packing cups
Washer
237-10
800-G01
29-G28
3-5
21-1
5-1
2.) After removing the front cap, what is the recommended tool for removing the conical
ejector and lock nut? (2 pts.)
Answer: Albion recommends a 7/16th nut driver or wrench to remove the ejector and
lock nut.
3.) What is the recommended way to clean the leather packing cups after use? (2 pts.)
Answer: Clean the packing cups in the solvent recommended by the material
manufacturer. The gun will hold up to all solvents.
4.) True or False: Once cleaned, the leather packing cups need to be soaked in motor oil
overnight before rebuilding your gun, for best performance. (1 pt.) True
5.) True or False: The thrust washer must remain in the gun. (1 pt.) True
6.) True or False: For best barrel swivel performance, when reassembling the barrel to the
drive, thread it down until there is just a slight drag. (1 pt.) True
7.) True or False: If your square rod is notched with wear, you can extend its life by
removing it and rotating ¼ turn. (1 pt.) True
2
Answer Key
8.) When reassembling the pistons, don’t thread the lock nut on too tight. What will
happen if the piston assembly is too tight? (1 pt.)
Answer: If too tight, the nut will sandwich the leather against the wall and it will be
difficult to draw on the gun.
Bonus Question: (5 pts.) What is the best way to confirm the gun is working properly once
it has been rebuilt?
Answer: Place the t-pull between your feet and pull back and forth to confirm that the
gun is working properly. Place your palm against the end of the barrel while pulling to
confirm that the gun develops a strong suction. If it doesn’t, tighten the lock nut.
3