SAFETY DATA SHEET
Issue Date 28-May-15
Revision Date 28-May-2015
Version 1
1. IDENTIFICATION
Product identifier
Product Name
DIAL MANUFACTURING, INC. SUBMARINE COOLER COATING
Other means of identification
Product Code
Synonyms
DM200
None
Recommended use of the chemical and restrictions on use
Recommended Use
Sealant.
Uses advised against
No information available
Details of the supplier of the safety data sheet
Manufacturer Address
HENRY COMPANY
999 N. Sepulveda Blvd., Suite 800
El Segundo, CA 90245-2716
Company Contact: Technical Services
Telephone Number: 800-486-1278
Web Site: www.henry.com www.ca.henry.com
Emergency telephone number
Emergency Telephone
CHEMTREC: 800-424-9300
CHEMTREC: 703-527-3887
CANUTEC: 613-966-6666
2. HAZARDS IDENTIFICATION
Classification
OSHA Regulatory Status
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200)
Acute toxicity - Oral
Acute toxicity - Dermal
Acute toxicity - Inhalation (Gases)
Acute toxicity - Inhalation (Vapors)
Acute toxicity - Inhalation (Dusts/Mists)
Skin corrosion/irritation
Serious eye damage/eye irritation
Respiratory sensitization
Skin sensitization
Germ cell mutagenicity
Carcinogenicity
Reproductive toxicity
Specific target organ toxicity (single exposure)
Specific target organ toxicity (repeated exposure)
Aspiration toxicity
Not classified
Not classified
Not classified
Not classified
Not classified
Category 2
Category 2
Not classified
Not classified
Not classified
Not classified
Not classified
Category 3
Not classified
Not classified
Label elements
Emergency Overview
_____________________________________________________________________________________________
Page 1 / 8
DM200 - DIAL MANUFACTURING, INC. SUBMARINE
Revision Date 28-May-2015
COOLER COATING
_____________________________________________________________________________________________
Warning
Hazard statements
Causes skin irritation
Causes serious eye irritation
May cause respiratory irritation
Appearance paste
Physical state No information available
Odor Slight
Precautionary Statements - Prevention
Wear protective gloves/protective clothing/eye protection/face protection
Wash hands thoroughly after handling
Avoid breathing dust/fume/gas/mist/vapors/spray
Use only outdoors or in a well-ventilated area
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing
If eye irritation persists: Get medical advice/attention
IF ON SKIN: Wash with plenty of soap and water
If skin irritation occurs: Get medical advice/attention
Wash contaminated clothing before reuse
IF INHALED: Call a POISON CENTER or doctor if you feel unwell
Precautionary Statements - Storage
Store in a well-ventilated place. Keep container tightly closed
Store locked up
Precautionary Statements - Disposal
Dispose of contents/container to an approved waste disposal plant
Hazards not otherwise classified (HNOC)
Not applicable
Other Information
IARC has classified occupational exposure to straight-run bitumens and their emissions during road paving as a carcinogen
(category 2B - possibly carcinogenic to humans).
Unknown acute toxicity
0% of the mixture consists of ingredient(s) of unknown toxicity
3. COMPOSITION/INFORMATION ON INGREDIENTS
Substance
Chemical Name
CAS No.
Weight-%
Trade Secret
Petroleum Asphalt
8052-42-4
30 - 60
*
Water
7732-18-5
20 - 50
*
Clays
NA – Mixture
5 - 15
*
*The exact percentage (concentration) of composition has been withheld as a trade secret.
_____________________________________________________________________________________________
Page 2 / 8
DM200 - DIAL MANUFACTURING, INC. SUBMARINE
Revision Date 28-May-2015
COOLER COATING
_____________________________________________________________________________________________
4. FIRST AID MEASURES
Description of first aid measures
Eye contact
Rinse thoroughly with plenty of water for at least 15 minutes, lifting lower and upper eyelids.
Consult a physician.
Skin contact
Wash skin with soap and water.
Inhalation
Remove to fresh air.
Ingestion
Clean mouth with water and drink afterwards plenty of water.
Most important symptoms and effects, both acute and delayed
Symptoms
No information available.
Indication of any immediate medical attention and special treatment needed
Note to physicians
Treat symptomatically.
5. FIRE-FIGHTING MEASURES
Suitable extinguishing media
Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.
Unsuitable extinguishing media CAUTION: Use of water spray when fighting fire may be inefficient.
Specific hazards arising from the chemical
No information available.
Explosion data
Sensitivity to Mechanical Impact None.
Sensitivity to Static Discharge None.
Protective equipment and precautions for firefighters
As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full
protective gear.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Personal precautions
Ensure adequate ventilation, especially in confined areas.
Environmental precautions
Environmental precautions
See Section 12 for additional ecological information.
Methods and material for containment and cleaning up
Methods for containment
Prevent further leakage or spillage if safe to do so.
Methods for cleaning up
Pick up and transfer to properly labeled containers.
7. HANDLING AND STORAGE
_____________________________________________________________________________________________
Page 3 / 8
DM200 - DIAL MANUFACTURING, INC. SUBMARINE
Revision Date 28-May-2015
COOLER COATING
_____________________________________________________________________________________________
Precautions for safe handling
Advice on safe handling
Handle in accordance with good industrial hygiene and safety practice.
Conditions for safe storage, including any incompatibilities
Storage Conditions
Keep containers tightly closed in a dry, cool and well-ventilated place.
Incompatible materials
None known based on information supplied.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Control parameters
Exposure Guidelines
Chemical Name
Petroleum Asphalt
8052-42-4
This product, as supplied, does not contain any hazardous materials with occupational
exposure limits established by the region specific regulatory bodies.
ACGIH TLV
3
TWA: 0.5 mg/m benzene soluble
aerosol fume, inhalable fraction
OSHA PEL
-
NIOSH IDLH
3
Ceiling: 5 mg/m fume 15 min
Appropriate engineering controls
Engineering Controls
Showers
Eyewash stations
Ventilation systems.
Individual protection measures, such as personal protective equipment
Eye/face protection
No special technical protective measures are necessary.
Skin and body protection
No special technical protective measures are necessary.
Respiratory protection
If exposure limits are exceeded or irritation is experienced, NIOSH/MSHA approved
respiratory protection should be worn. Positive-pressure supplied air respirators may be
required for high airborne contaminant concentrations. Respiratory protection must be
provided in accordance with current local regulations.
General Hygiene Considerations
Handle in accordance with good industrial hygiene and safety practice.
9. PHYSICAL AND CHEMICAL PROPERTIES
Information on basic physical and chemical properties
Physical state
Appearance
Color
No information available
paste
black
Property
pH
Melting point / freezing point
Boiling point / boiling range
Flash point
Evaporation rate
Flammability (solid, gas)
Flammability Limit in Air
Upper flammability limit:
Lower flammability limit:
Vapor pressure
Vapor density
Relative density
Values
6-9
No information available
> 100 °C
> 100 °C
No information available
No information available
Odor
Odor threshold
Slight
No information available
Remarks • Method
No information available
No information available
No information available
No information available
>1
_____________________________________________________________________________________________
Page 4 / 8
DM200 - DIAL MANUFACTURING, INC. SUBMARINE
Revision Date 28-May-2015
COOLER COATING
_____________________________________________________________________________________________
Water solubility
Solubility in other solvents
Partition coefficient
Autoignition temperature
Decomposition temperature
Kinematic viscosity
Dynamic viscosity
Explosive properties
Oxidizing properties
No information available
No information available
No information available
No information available
No information available
No information available
No information available
No information available
No information available
Other Information
Softening point
Molecular weight
VOC Content (%)
Density
Bulk density
No information available
No information available
No information available
No information available
No information available
10. STABILITY AND REACTIVITY
Reactivity
No data available
Chemical stability
Stable under recommended storage conditions.
Possibility of Hazardous Reactions
None under normal processing.
Conditions to avoid
Extremes of temperature and direct sunlight.
Incompatible materials
None known based on information supplied.
Hazardous Decomposition Products
None known based on information supplied.
11. TOXICOLOGICAL INFORMATION
Information on likely routes of exposure
Product Information
No data available
Inhalation
May cause irritation.
Eye contact
Severely irritating to eyes.
Skin contact
Irritating to skin.
Ingestion
No data available.
Chemical Name
Water
7732-18-5
Petroleum Asphalt
8052-42-4
Oral LD50
> 90 mL/kg ( Rat )
Dermal LD50
-
Inhalation LC50
-
> 5000 mg/kg ( Rat )
> 2000 mg/kg ( Rabbit )
-
Information on toxicological effects
Symptoms
No information available.
Delayed and immediate effects as well as chronic effects from short and long-term exposure
_____________________________________________________________________________________________
Page 5 / 8
DM200 - DIAL MANUFACTURING, INC. SUBMARINE
Revision Date 28-May-2015
COOLER COATING
_____________________________________________________________________________________________
Sensitization
Germ cell mutagenicity
Carcinogenicity
Chemical Name
Petroleum Asphalt
8052-42-4
No information available.
No information available.
No information available.
ACGIH
-
Reproductive toxicity
STOT - single exposure
STOT - repeated exposure
Aspiration hazard
IARC
Group 2B
NTP
-
OSHA
X
No information available.
No information available.
No information available.
No information available.
Numerical measures of toxicity - Product Information
ATEmix (oral)
ATEmix (dermal)
ATEmix (inhalation-gas)
ATEmix (inhalation-dust/mist)
ATEmix (inhalation-vapor)
8,000.00
8,000.00
99,999.00
20.00
99,999.00
12. ECOLOGICAL INFORMATION
Ecotoxicity
0 % of the mixture consists of components(s) of unknown hazards to the aquatic environment
Persistence and degradability
No information available.
Bioaccumulation
No information available.
Chemical Name
Petroleum Asphalt
8052-42-4
Other adverse effects
Ozone
Partition coefficient
>6
No information available
Not applicable
13. DISPOSAL CONSIDERATIONS
Waste treatment methods
Disposal of wastes
Disposal should be in accordance with applicable regional, national and local laws and
regulations.
Contaminated packaging
Do not reuse container.
14. TRANSPORT INFORMATION
DOT
Not regulated
TDG
Not regulated
_____________________________________________________________________________________________
Page 6 / 8
DM200 - DIAL MANUFACTURING, INC. SUBMARINE
Revision Date 28-May-2015
COOLER COATING
_____________________________________________________________________________________________
IATA
Not regulated
IMDG
Not regulated
15. REGULATORY INFORMATION
International Inventories
TSCA
DSL/NDSL
EINECS/ELINCS
ENCS
IECSC
KECL
PICCS
AICS
Complies
Complies
Complies
Does not comply
Complies
Complies
Complies
Complies
Legend:
TSCA - United States Toxic Substances Control Act Section 8(b) Inventory
DSL/NDSL - Canadian Domestic Substances List/Non-Domestic Substances List
EINECS/ELINCS - European Inventory of Existing Chemical Substances/European List of Notified Chemical Substances
ENCS - Japan Existing and New Chemical Substances
IECSC - China Inventory of Existing Chemical Substances
KECL - Korean Existing and Evaluated Chemical Substances
PICCS - Philippines Inventory of Chemicals and Chemical Substances
AICS - Australian Inventory of Chemical Substances
US Federal Regulations
SARA 313
Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA). This product does not contain any
chemicals which are subject to the reporting requirements of the Act and Title 40 of the Code of Federal Regulations, Part 372
SARA 311/312 Hazard Categories
Acute health hazard
Chronic Health Hazard
Fire hazard
Sudden release of pressure hazard
Reactive Hazard
Yes
No
No
No
No
CWA (Clean Water Act)
This product does not contain any substances regulated as pollutants pursuant to the Clean Water Act (40 CFR 122.21 and 40
CFR 122.42)
CERCLA
This material, as supplied, does not contain any substances regulated as hazardous substances under the Comprehensive
Environmental Response Compensation and Liability Act (CERCLA) (40 CFR 302) or the Superfund Amendments and
Reauthorization Act (SARA) (40 CFR 355). There may be specific reporting requirements at the local, regional, or state level
pertaining to releases of this material
US State Regulations
California Proposition 65
Warning: This product contains chemicals known to the state of California to cause cancer.
_____________________________________________________________________________________________
Page 7 / 8
DM200 - DIAL MANUFACTURING, INC. SUBMARINE
Revision Date 28-May-2015
COOLER COATING
_____________________________________________________________________________________________
U.S. State Right-to-Know Regulations
All chemicals listing in accordance with US State Right-to-Know Regulations.
U.S. EPA Label Information
EPA Pesticide Registration Number Not applicable
16. OTHER INFORMATION, INCLUDING DATE OF PREPARATION OF THE LAST REVISION
NFPA
Health hazards 1
Flammability 1
Instability 0
HMIS
Health hazards 1
Flammability 1
Physical hazards 0
Physical and Chemical
Properties Personal protection X
Revision Date
28-May-2015
Revision Note
No information available
Disclaimer
The information provided in this Material Safety Data Sheet is correct to the best of our knowledge, information and belief
at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing,
storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The
information relates only to the specific material designated and may not be valid for such material used in combination
with any other materials or in any process, unless specified in the text.
End of Safety Data Sheet
_____________________________________________________________________________________________
Page 8 / 8