Ethernet to E1 Converter
- SVPE48 Series
SVPE48 Series, Inverse Multiplexer, are worked as
network termination units for connecting Fast
Ethernet over multiple (4xE1) bonded E1 circuits.
These devices can build scalable, virtual and steady
large pipe from individual E1. It is available as a
standalone unit or inserted as a module card into a
chassis CHAS02. Fast and easy deployment, remote
and convenient management, all of these
advantages will be reducing investment of carriers
and ISPs.
SPECIFICATIONS
10/100Base-Tx
• 4*10/100Base-Tx Auto-negotiation
Duplex
• Compatibility: Relevant sections of
IEEE802.3x; IEEE-802.3u
• Connector: RJ45
• Data rate: 10/100M Auto-negotiation
FEATURES
10/100Base-Fx
• Provide from 4 x E1 with 75ohm unbalanced or 120ohm
balanced interface.
• Maximum 4x10/100Base Tx and 100Base Fx are
available. Support local swithcing and isolated port
based on VLAN functions
• Selectable data rate based on ports
• Available priority function based on IEEE802.1p
• Compliance to IEEE802.3x–flow control for PAUSE Frame
• Suppress broadcast storm
• Support VCAT function based on ITU G.7043. Auto-adapt
• 100Base-Fx Full Duplex
• Transmitter optical power: -3dbm~8dbm
• Receiver sensitivity: -33dbm~-40dbm
• Connector: SC or FC optional
E1 Interface
• Bit Rate: 2048Kbps
• Line Code: HDB3
• Line Impedance: 75ohm unbalanced or
120ohm balanced
• Electrical Characteristic: ITU-T G.703
• Jitter Performance: ITU-T G.823
• Connector: BNC unbalanced; RJ45
balanced
the maximum 240ms time delay difference
• Support SNMP and Console management and
upgrade software online
• Support Traffic load balance and Fault self recovery
functions on E1 circuits.
Management Port
Console Port
• Interface: RS-232
• Connector: RJ45
• Baud rate: 57600bit/s
• Support loop-back on E1 circuits.
• Support priority and flow control to guarantee better Qos
based on VLAN and IEEE802.1q TAG QinQ VLAN functions
• Compliance to ITU G.8040 standard- mapping GFP into load
of PDH;
• AC or DC or Universal Power supply
General
• Power Supply
AC: 220VAC±20%; 50HZ DC: 24VDC or -48VDC
• Power Consumption ≤ 10W
• Working Environment
Temperature: 0°C~45°C
Humidity: Up to 90% non-condensing
APPLICATION
In this point to point application, SVPE is acted as network termination units (NTUs) for connecting LANs over
multiple bonded E1 circuits. The SVPE provide 4 x E1 and one, two or four Ethernet. NMS are available for both
central rack and standalone option.
ORDERING INFORMATION
SVPE48
Standalone; 4*10/100Base-Tx to 4*E1 Converter; SNMP management; 220VAC or -48VDC
SVPE48x
Standalone; 1*10/100Base-Fx and 4*10/100Base-Tx to 4*E1; SNMP management; 220VAC or -48VDC
KSVPE48
Module Card; 4*10/100Base-Tx to 4*E1 Converter; SNMP management
KSVPE48x
Module Card; 1*10/100Base-Fx and 4*10/100Base-Tx to 4*E1; SNMP management