4.
1.
3.
2.
Part 1.
1pc
Part 3.
1 pc
Part 2.
1 pc
Part 4.
1 pc
There are 2 pcs of keys (24 mm) to fix part 1. together with part 3.
1.
2.
Connect part 3 with part 1, see picture below.
Put screws in holes and fix by nuts (to do this you can use enclosed keys).
3
1
1.
2.
Adjust requested tilting position of snow blade to the drawbar and fix it with
part nr. 4. (part nr. 4 is adjustable by turning).
Make sure part 4. is fixed by locking pins properly.
3
Lift the pin eye, put
the pin into the hole
and fix the eye.
4
1
1.
2.
Insert part nr. 2 in part nr. 1 and screw the nut. Thread should overhang the nut
by 3 mm at least.
Adjust the exact position of part nr. 2 by turning fixative part B when connecting
snow blade to the car.
2
1
B
1.
2.
3.
Connect part A (coupling ) of snow blade to the car.
Tilt part nr. 1 to requested position and fix it by part nr. 4. Draw bar of snow blade
has to be in the parallel position with car – see picture nr. 1.
Adjust part nr. 2 to the position that it is possible to put it into towing eye on
your car (part C) and fix it.
obr. 1
4
B
A
1
2
C
Use manipulation wheels for snow blade transport only. Do not use it while snow
removing.
Manipulation wheels have to be lifted up and fixed (picture nr. 2, 3) when snow
remowing .
obr. 2
obr. 3
Total weight:
Width:
Max. speed:
65 kg
2m
30km/h
 There is rubber strip along scrapper part of snow blade. It is considerred
as consumption material and is not covered by warranty.
 In case of excessive usage it can be turned by 180° for the next usage.
 Rubber part can be bought as spare part at : www.ebeco-eshop.com
WARNINGS AND RECOMMEDATIONS:




This product is not homologated for road usage.
Be carefull when reversing.
Keep maximum speed 30 km/h.
Pred jazdou si skontrolujte všetky časti pluhu, aby boli správne osadené a
upevnené.
 Before snow blade usage check all parts are correctly settled and fixed.
Dealer
Stamp:
www.ebeco.eshop.com
[email protected]
Date: