Blade and Teardrop Flagpole Instructions
Item #: BTS9, BTM12, BTL16 Depending on the size of the pole that you are assembling you will have two (BTS9), three (BTM12) or four (BTL16) pole sections. Always start with the largest pole section. This piece is the bottom of the pole. Each section of the pole slides into the next from largest to smallest until the pole is completely assembled. Remove the bungee cord from the mesh pocket on the inside of the carrying case. This is needed for flag attachment. Slide the sleeve of the flag over the top of the pole. When you place the flag on the pole the pole will bend to take the shape of the flag. Loop the bungee through the leather tab on the bottom of the flag. Tighten the bungee to provide enough tension for the flag to arch. Tie the bungee cord to the knob located at the bottom of the pole to secure it in place. There is a mounting hole in the bottom of these poles, which can be used with a rotating ground spike or a crossbase with waterbag. The ground spikes (TELGS or GSP1) and crossbase with waterbag (CRW1) are not included and must be purchased separately.