Deck Permit Application Requirements With the submission of a

Deck Permit Application Requirements
With the submission of a Deck Permit Application please provide the following
documents:
1. A complete building permit application form
2. A survey or plot plan showing the property lines and the location of
proposed deck dimensioned to all buildings and property lines
3. Two copies of the deck construction drawings. The drawings must have
sufficient detail so that someone, following the drawings, could build the
deck
Construction Drawings
The construction drawings must contain the following details:
1. Foundation Plan detailing
2. Footing size and location
3. Size, span, and direction, of beams
4. Size, span, and direction of floor joists and decking
5. Dimensions of all components
The construction drawings must contain elevations to demonstrate the following:
1. The general appearance of the deck
2. Cross Section detailing
3. Footing depth and construction
4. Height of deck walking surface above grade
5. Height of guard above walking surface
6. Step details
7. Deck construction
8. Guard construction
9. Details, such as deck to house connection
Indicate the following on the Site Plan:
1. Overall deck dimensions
2. Location of deck in relation to house
3. Location of deck in relation to lot lines
4. Stair location(s) and width
Guards and Handrails
Guards and handrail details must conform to the Ontario Building Code SB-7
Guards for Housing and Small Buildings Guidelines. If using a guard not listed in
the SB-7 Guidelines, two copies of manufacturer's installation instructions for
proprietary products stamped and signed by an engineer must be submitted.
Please ask for details where you purchase the system.
Permit Fees
Permit fees are calculated based on $0.38/sq.ft, $12/$1000 of the total
construction value, or a minimum of twenty five dollars ($25). Accepted
methods of payment are cheque, cash, or debit card.
Permits are typically issued within ten business days provided the
application submission is complete.
BUILDING DEPARTMENT
285 County Rd 44, Box 130
Phone: (613)258-9569 ext. 130
Fax: (613)258-1441
ATTACHED DECK
NAME:
_
BUILDING PERMIT NO:
_
ADDRESS:
_
REVIEWED BY:
_
DATE:
_
DATE REVIEWED:
_
GUARDS SHALL BE CONSTRUCTED AND CONNECTED AS
PER 2012 OBC SUPPLEMENTARY STANDARD SB-7 DETAIL
NO.: _______________
FOOTING
PLEASE SEE REVERSE SIDE FOR ADDITIONAL INFORMATION
BUILDING SECTION
LOCATION: 77 Beckwith St N
PHONE: 613-283-4124, EXT 1128
FAX: 613-283-0558
ATTACHED DECK
BEAM SPANS FOR DECKS
FLOOR JOIST SPANS FOR DECKS
(2) 2X8………..………..…………….5’-10” (1.8m)
(2) 2X10……………………………...7’-2” (2.2m)
(2) 2X12……………….……………..8’-4” (2.56m)
2X8@12”.....................................11’-7” (3.54m)
2X8@16”.....................................11’-0” (3.36m)
2X8@24”.....................................10’-6” (3.2m)
(3) 2X8……………………….………7’-3” (2.21m)
(3) 2X10……………………………...8’-10” (2.7m)
(3) 2X12……………………..………10’-3” (3.13m)
2X10@12”...................................13’-8” (4.17m)
2X10@16”...................................13’-0” (3.96m)
2X10@24”...................................12’-4” (3.77m)
(4) 2X8………………………….……8’-4” (2.55m)
(4) 2X10………………………..……10’-2” (3.12m)
(4) 2X12……………………………..11’-10” (3.62m)
2X12@12”...................................15’-7” (4.75m)
2X12@16”...................................14’-9” (4.52m)
2X12@24”...................................14’-1” (4.30m)
BUILT UP BEAM SPANS AS PER TABLE A-12 AND A-15 2006 BUILDING
CODE
JOIST SPANS AS PER TABLE A-1 2006 BUILDING CODE
ADDITIONAL INFORMATION (CHECKLIST):
1.
INDICATE THE FOLLOWING ON REVERSE PAGE:
LENGTH OF LAG BOLTS
SIZE OF LEDGER
JOIST SPAN AND CANTILEVER
BEAM SPAN AND CANTILEVER
JOIST SIZE AND SPACING
BEAM SIZE AND NUMBER OF PLY
POST SIZES TO BE 140mm x 140mm
SONO TUBES TO BE MIN. 229mm TO 1200mm BELOW FINISHED GRADE
SB-7 DETAIL NUMBER FOR GUARDS (SEE BOOKLET)
STAIR CONSTRUCTION
2.
INDICATE THE FOLLOWING ON THE PLOT PLAN:
OVERALL DECK DIMENSIONS
LOCATION OF DECK IN RELATION TO HOUSE
LOCATION OF DECK IN RELATION TO LOT LINES
STAIR LOCATION (S) AND WIDTH
3.
CONFIRM BEAM CANTILEVER WITH INSPECTOR
MAX. CANTLEVER FOR 38x184 JOISTS = 400mm
MAX. CANTILEVER FOR 38x235 JOISTS = 600mm
MAX. CANTILEVER = 1/6 OF JOIST SPAN
I
(PRINT NAME)
HEREBY AGREE TO CONSTRUCT THE DECK IN ACCORDANCE
WITH THE SUPPLIED INFORMATION NOTED ON PREVIOUS PAGE AND ABOVE.
SIGNATURE:
(OWNER/APPLICANT)
DATE:
_
REFER TO OTHER SIDE FOR FURTHER INFORMATION