Enriching Childhood Through Pf4!i.\
Recycled Content Value
The LEED Green
Building Rating
System TM is a
voluntary, consensus
-based national
standard for
developing
high- performance,
sustainable buildings.
The recycled content value of project materials is an important figure in your LEED�
project. Different percentages of both post and pre-consumer recycled material are
required for different LEED credits, and the recycled content value of an assembly is
determined by weight. This recycled fraction of the assembly is then multiplied by the
cost of the assembly to determine recycled content value. Below is the recycled
content value of the individual materials used by Game Time which can then be used to
calculate the recycled content value of an entire project. This figure is especially
important if applying for LEED MR (Materials & Resources) Credits. An example of
applying this equation would be as follows. Consider if a projects material assembly
had a total weight of 100 lbs. and 50 lbs. (or .50) of the projects material assembly was
made of recycled materials. If the total cost of the material assembly for the project in
question was $1,000, you would multiply the fraction of the assembly that constituted
recycled content (.50) by the total cost of material assembly ($1,000) to attain the
recycled content value of $500. (.50 x 1,000 = 500)
Type of Material
Aluminum
Found in These Products
Structural Uprights
% Pre-Consumer
Aluminum Castings
Cardboard Packaging
Post Caps, Castings
Packing, Shipping
Handles, Handholds, Small
Components
40%
Poly Tubing
Recycled Plastics
Injection Molded Plastics
0%
0%
40-50%
15%
Black 100%
Packing, Shipping
0%
Clear 50%
Triangle Deck, Square Deck,
Rectangular Deck, Roofs
0%
100%
0%
0%
Black 100%
0%
Bigfoot Slide, Wallcano,
Rotation Molded Plastics All
Tubes, Slides, Panels, Cruisin'
rotation molded plastic components
Mates
made from 100% recyclable resins.
PlayCurbs
Content courtesy of
U.S. Green Building
Council.
www.usgbc.org
40%
% Post-Consumer
5%
Rubber Products
GT impax Poured in Place,
Shredded Rubber, Bonded
Shredded Rubber Surfacing
0%
100%
Steel Plates and Sheets
Slides, Decking, Steps, Roofs,
Site Furniture, Mirror Panel,
Grills, Whirls
30%
68%
Stainless Steel
Mirror Panels, Slides, Tabs
0%
65%
0%
50%
0%
100%
50%
0%
Steel Wire
Play Structure Uprights,
Center Supports, Ladders,
Climbers, Railings
Sky Bridge, Balustrade
Thermoformed Plastic
Roof Panels
Steel Tubing
Recycled Content
GameTime’s Dedication to Our Environment
Type of Material
Found in These Products
% We use
% Pre-Consumer
% Post-Consumer
Aluminum
Structure uprights
100%
40%
25%
Aluminum Castings
Post caps, castings
100%
40%
0%
Cardboard Packaging
Packing, shipping
100%
0%
80%
Injection Molded Plastics
Handles, handholds, small
components
100%
5%
0%
Poly Tubing
Packaging, shipping
100%
0%
Clear 30%
Recycled Plastics
Triangle deck, square deck,
rectangular deck, roofs
100%
0%
100%
Rotation Molded Plastics
BigFoot slide, Wallcano,
tubes, slides, panels,
Cruisin’ Mates
100%
0%
0%
Rotation Molded Plastics
PlayCurbs
100%
Black 100%
0%
Rubber Products
GT Impax poured in place,
shredded rubber, bonded
shredded rubber surfacing
100%
0%
100%
Steel Plates and Sheets
Slides, decking, steps,
roofs, site furniture, mirror
panel, grills, whirls
100%
20-30%
0-30%
Stainless Steel
Mirror panels, slides, tabs
100%
0%
65%
Steel Tubing
Play structure uprights,
center supports, skate park
framing, ladders, climbers,
railings, spray park
elements
100%
50%
0%
Steel Wire
SkyBridge, Balustrade
100%
0%
100%
Thermoformed Plastic
TOTSTUFF product
components
100%
50%
0%
GameTime actively maintains an environmental management system in compliance with the requirements
of the Alabama Department of Environmental Management., and adheres to the federal requirements of the
EPA. All of the materials listed above constitute recyclable product, in areas where such recycling facilities
exist. GameTime is committed to our environment by conscientiously maintaining a dedication to the use
of recycled/reclaimed materials to the extent that they don’t affect the strength, durability and quality that we
have built our reputation upon.
© 2003 GameTime, a PlayCore company.
1-800-235-2440
WWW.GAMETIME.COM
From:
To:
Subject:
Date:
Attachments:
Jeannot, Vladimir
Mendoza, Luis
FW: Gametime Playgrounds (3D Renderings)
Friday, February 12, 2016 2:33:08 PM
image001.png
GameTime Renders - Miami - Maceo Park (1).pdf
GameTime Renders - Miami - Maceo Park (2).pdf
GameTime Renders - Miami - Maceo Park (3).pdf
image002.png
See attached.
Sincerely yours,
Vladimir Jeannot, CPSI
Construction Coordinator
Parks & Recreation
444 SW 2nd Ave 8th Floor | Miami, FL 33130
Phone: (305) 416-1780 | Cell: 305-389-9360
Email: [email protected] www.miamigov.com/parks From: Roy May [mailto:[email protected]]
Sent: Tuesday, February 9, 2016 3:03 PM
To: Bayona, Omar
Cc: Jeannot, Vladimir; Rob Dominica
Subject: Gametime Playgrounds (3D Renderings)
HI Vladirmir and Omar
See attached
Rob used some colors to make things look better in the 3D renderings. We can always tweak them
later for your color choices.
Take Care
Roy
Roy May
South Florida Territory Manager