Each set of Sweet ‘N Sassy Templates™ consists of three different sizes of rhombus shapes. Each shape can be cut
from strips and sewn together to create a design.
Cutting from One Fabric:
Template #1:
Cut 2" strips. Place Template #1 over this strip and cut around the template on the two short sides. Each strip yields
15 pieces.
Template #2:
Cut 2 1/2" strips. Place Template #2 over this strip and cut around the template on all sides. Each strip yields 9
pieces.
Template #3:
Cut 4 1/2" strips. Place Template #3 over this strip and cut around the template on all sides. Each strip yields 6
pieces.
These Rhombus Units can also be cut from pieced strips.
Piecing the Large Rhombus (Diamond):
1. Cut two – 2 1/2" strips of coordinating prints the width of the fabric. (These units will be trimmed after
sewing is complete so pre-cut strips or scraps that are at least 2 1/2" wide can be used.) Sew these strips
together with a 1/4" seam. Press the seam toward the dark fabric.
2. Place the Creative Grids® #3 Rhombus Template on the strip set – matching the line on the template to the
seam line. Rotary cut along each angled edge. The top and bottom edges will be trimmed when the units are
sewn together.
3.
Place the Creative Grids® #3 Rhombus Template on the wrong side of each unit. Mark the 1/4" seam
allowance through the hole with a water soluble marker.
4. Place two units – right sides together – reversing fabrics. Pin through the marked dots to match seams. Sew
these units together with a ¼" seam. Press this seam open.
5.
Place the Creative Grids® #3 Rhombus Template on this pieced unit – matching the lines on the template
with the seam lines.
6.
Trim the fabric even with the template on all sides. (Save the two end pieces. These can be sewn into a
miniature version using the Creative Grids® #2 Rhombus Too Template.)
Piecing the Small Rhombus (from Scraps):
1.
Place the Creative Grids® #2 Rhombus Too Template on the wrong side of each end piece. Mark the 1/4"
seam allowance through the hole with a water soluble marker.
2.
Place two units – right sides together – reversing fabrics. Pin through the marked dots to match seams.
3.
Sew these units together with a 1/4" seam. Press this seam open. Place the Creative Grids® #2 Rhombus
Template on this pieced unit – matching the lines on the template with the seam lines.
4. Trim the fabric even with the template on all sides. These mini’s can be used to make a miniature version of
the original design.
Creative Grids® USA, Inc.
400 W. Dussel Dr. Ste B,
Maumee, OH 43537
www.creativegridsUSA.com
UK Website: www.creativegrids.com
Creative Grids is a registered trademark of Creative Grids UK, Ltd., and is used under license by Creative Grids
USA, Inc.
4.20.11.2