537809 Lalaloopsy Tinies Jewelry Maker Pg 1-4

TROUBLESHOOTING
• To avoid jamming, do not fill beads above the fill line.
• If beads become jammed in the Jewelry Maker, an adult should remove the dome and manually turn the dial
underneath until beads loosen.
For ages 4+
ADULT SUPERVISION REQUIRED
537809
CONTENTS
A. Lalaloopsy Tinies™ Ferris Wheel
B. 1 Dome
C. 2 Spools of Lanyard
D. 60 Pink Beads
E. 60 Yellow Beads
F. 60 Green Beads
G. 60 Blue Beads
H. 60 Orange Beads
I. 1 Lalaloopsy Tinies™ Crumbs Sugar Cookie™
J. 1 Lalaloopsy Tinies™ Mittens Fluff ‘N Stuff™
K. 1 Lalaloopsy Tinies™ Jewel Sparkles™
L. 1 Lalaloopsy Tinies™ Pet Cat
SAFE BATTERY USAGE
• Use alkaline batteries for best performance and longer life.
• Use only the type battery recommended for the unit.
• Batteries should be replaced only by an adult.
• Insert batteries with the correct polarity ( + and – ).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable(nickel-cadmium) batteries.
• Do not short-circuit batteries.
• When not used for an extended time, remove batteries to prevent possible leakage
and damage to the unit.
• Do not mix rechargeable and non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• Do not recharge non-rechargeable batteries.
• Exhausted batteries are to be removed from the toy.
• Do not dispose of batteries in fire as they may leak or explode.
‘Let’s care for the environment!’
The wheelie bin symbol indicates that the product must not be disposed of with other household waste. Please use
designated collection points or recycling facilities when disposing of the item.
Do not treat old batteries as household waste. Take them to a designated recycling facility.
Please keep this manual as it contains important information.
0515-1-E
4
www.lalaloopsy.com
© 2015 MGA Entertainment, Inc.
The preferred method of contact for
LALALOOPSY™, LALALOOPSY MINIS™,
Customer Service is through our e-mail
LALALOOPSY TINIES™, LALALOOPSY PET PALS™,
contact form at www.mgae.com
LALALOOPSY BABIES™ and LALALOOPSY GIRLS™
are trademarks of MGA in the
U.S. and other countries. All logos,
MGA Entertainment UK Ltd.
names, characters, likenesses,
50 Presley Way
images, slogans, and packaging
Visit
appearance are the property
Crownhill
.com
of MGA.
Milton Keynes
to register your product
16300 Roscoe Blvd.
and to enter our sweepstakes
MK8 0ES
(No purchase necessary)
Van Nuys, CA 91406 U.S.A.
Bucks, UK
(800) 222-4685
+ 0800 521 558
Printed in China
A.
C.
D.
C.
x60
E.
F.
x60
G.
x60
H.
x60
x60
B.
I.
J.
K.
L.
BEFORE YOU BEGIN
Prior to playing, an adult must install fresh
alkaline batteries (not included) in the
Lalaloopsy Tinies™ Jewelry Maker. Here’s how:
1. Using a Phillips screwdriver (not included),
remove the screw and battery
compartment cover located under the
base of the Ferris wheel.
2. Install three (3) AA alkaline batteries (not
included), making sure the (+) and (-) ends
face the proper direction as indicated
inside the battery compartment.
3. Replace the compartment cover and
tighten the screw.
1.5V AA/LR6
1.5V AA/LR6
1.5V AA/LR6
1
QUICK START
1
2
BOTTOM VIEW
OF TEACUP
5
6
ON/OFF
loop
CLOSED
OPEN
Insert the back of the dome into the base of
the Ferris wheel, then snap the front into place
as shown. Insert the spools of lanyard into the
base.
Twist the bottom of the teacups until they are
in the closed position.
Thread the lanyard through the loop and
hold both ends between your thumb and
index finger. Pull the lanyard taut without
yanking it.
Press the flower button and watch the beads
thread onto the lanyard! Keep the loop and
lanyard centered in the dome opening so that the
beads exit the dome easily. When the lanyard
reaches the desired length, press the flower
button to turn the jewelry maker off.
8
7
3
4
FILL LINE
Fill each teacup with different beads. Then,
close the teacup lids.
2
Spin the Ferris wheel around. When a teacup
is over the dome, twist the bottom of the
teacup to the open position to release the
beads into the dome.
NOTE: Only fill the dome up to the fill line.
Ask an adult to cut the lanyard off the spool.
Let go of one end of the lanyard and carefully
pull the lanyard through the loop. Grab the
loose ends so that all beads are on one strand.
Double knot the lanyard ends together.
Take your Lalaloopsy Tinies™ along for a ride!
Place them on the pegs inside the teacups
and spin them around!
TIPS
• Remove the dome and turn it over to remove extra beads.
• Add one color bead to the dome at a time and turn the unit on to create bead patterns for your
jewelry. (For example: green, pink, yellow, green, pink, yellow...)
• Thread Lalaloopsy Tinies™ characters onto the lanyard before knotting it.
• Cut the lanyard to the desired length before adding beads to make sure you are using the
proper amount of lanyard.
• To avoid damaging the unit, place only beads in the dome.
• Beads used in the jewelry maker must have a minimum opening of 2.5 mm.
• Store the unit in a safe place to avoid possible damage.
3